Find an experienced cabinet maker in Richmond VIC

Cabinetry adjustment above gas stove – make compliant I need a cabinetmaker/handyman to modify the existing overhead cabinetry above a freestanding gas stove in a Richmond apartment. The current cupboard/extraction fan enclosure sits too low and protrudes over the cooktop. I need the cabinetry altered so there is sufficient clearance above the gas cooktop and the area can meet the applicable installation/compliance requirements. Work would likely involve: * Cutting back, shortening or reconfiguring the cupboard directly above the stove. * Adjusting/removing the lower section that currently protrudes over the cooktop. * Making good the cabinetry after alteration so it looks neat and finished. * Coordinating the finished dimensions with the required clearance for the gas cooktop/rangehood. Cabinet: any combustible cabinet surface directly above the gas cooktop should ideally be 650 mm or more above the top of the gas trivet. If it is lower than 650 mm, it needs compliant protection; nothing can be below 450 mm. an Photos attached showing the existing setup. Please quote for labour and materials and advise how you would modify it. Ideally looking for someone experienced with kitchen cabinetry and gas cooktop/rangehood clearance requirements.

Kitchen required to be altered so dishwasher can be installed. Dishwasher to go under sink area. New single sink installed.

Im doing an install tomorrow morning in Richmond, looking for a labourer for the day to assist lifting a couple cabinets in situe. Must have some tools and ladder. Kickers already down and carcass mostly installed. Duties will be. Installing hinges (screw in already drilled drilled) Cleaning capping Assistance lifting above bench units (will be heavy) - other duties too pending experience level. Cheers

i need to add 4 shelves to a wardrobe cupboard. 55cm wide by about 52cm .

I need a cabinet maker to raise cabinetry so cooktop burner is at least 650mm distance from lowest part of rangehood or cabinetry. The current clearance is 605mm.

I need a cabinetmaker to come and measure and quote for a small bespoke dental surgery. One surgery , sterilising room and tea room cabinets. Including measure quote instal etc

We have a space between fireplace and wall (both brick) that we would like an alcove desk with two shelves built above it. Ideally the taskee would source wood, hardwood for desk ideally, and materials to construct desk. Space is 106cm wide and desk would come out around 60cm, although flexible. We have a panel from bunnings that we would like bought for the task.

We are in need of some cabinet maker or people that are experienced with joinery to help on site. $40.00 an hour for 8 hours - Due date: Needs to be done on Friday, 2 December 2022

Looking for a cabinet maker to assist removing in wall wardrobe and create a new one to replace the existing. The door will be plastered so in the main room I’m looking to have a wardrobe for the full length of the wall. Happy to discuss quote to complete the work