Find a professional local car service in Inner South West Sydney

Van damage from reversing into lowered roof, want to prevent rust damage and bring shape roughly back to original. Ideally someone to beat it roughly into shape from the inside and a protective spray paint. Does not have to be perfect but want to prevent further rust damage. The top reverse tail light does not fit into hole due to deformed metal at the top of rear door. Would like to get that fixed to allow the tail light to sit flush and have an intact seal around it to prevent water ingress

I have the parts ready, just need someone who can come to me.

I bought 7 inch Kings Spotlights, they are already mounted however i need them to be wired to my car.

Toyota Camry 2020 sedan No existing tints Have an empty double car garage with power and light. Would like all windows tinted, please. Note: We have additional cars that will need tinting as well depending on how this goes.

Looking for someone who can supply + install to fit a 3-channel dash cam (Front, Cabin/Interior, & Rear) in my 2021 Toyota Camry Sedan (Non-Hybrid).My ​Preferred model is REDTIGER A6, REDTIGER A3, AZDOME M580, or a similar 3-channel setup (Must support Front + Cabin IR Night Vision + Rear and Wi-Fi Mobile App connectivity).Needs clean wiring so the camera automatically turns on/off with vehicle ignition and saves footage smoothly to an SD card.I am located in Wiley Park (2195) and can host you if you offer mobile installation, but I am also happy to drive to your workshop/location nearby in Sydney.

Need someone to jump start my car kia 2013 cerato sedan in Bexley

Window tint 5 doors (including boot window)

Sounds like front brake pads are touching as the bike makes a shhh sound everytime the wheel is rotated have checked pad clearance think forks maybe twisted or disc is warped will need a diagnosis 300 for repair will not pay for only diagnosis

Remove aftermarket wiring and install wiring to factory

I need an experienced dashcam installer to professionally install a DDPAI Z60 4K front-and-rear dashcam in my brand-new 2026 Toyota Yaris Cross Hybrid. I have already purchased: * DDPAI Z60 front-and-rear dashcam * Genuine DDPAI OBD hardwire kit compatible with the Z60 * SanDisk 256GB microSD card The installation must include: * Correct positioning and installation of both cameras * Neatly concealing all front and rear camera wiring * Connecting the supplied DDPAI OBD hardwire kit * Enabling and testing 24-hour parking-monitoring mode * Routing cables safely without interfering with the curtain airbags * Setting up the DDPAI app, Wi-Fi, GPS and recording settings * Formatting and checking the 256GB memory card * Testing recording from both cameras while driving and parked * Leaving no exposed wiring, loose trim or damage to the vehicle This task is for installation labour only, as I already have the camera, OBD hardwire kit and memory card. Please only make an offer if you have experience installing front-and-rear dashcams in modern Toyota or hybrid vehicles. In your offer, please mention your relevant experience and whether you provide a workmanship warranty.

Repair Cracked Upper Passenger Console Plastic – Toyota RAV4 2007 I have a 2007 Toyota RAV4 Cruiser and the upper passenger-side dashboard/console plastic is cracked, as shown in the photos. The previous owner tried to repair it using super glue, which is now very noticeable and looks messy. I’m looking for someone experienced with automotive interior plastic repairs to properly repair/reinforce the cracked section and finish it so the damage and previous super-glue repair are as unnoticeable as possible. Ideally, I want the original piece retained rather than replacing the entire console if it can be professionally repaired. Please only apply if you have experience repairing automotive interior plastics and can achieve a neat factory-like finish.

Repair Toyota RAV4 2007 Cruiser Heated Seat – Driver Side I have a 2007 Toyota RAV4 Cruiser with heated seats. The driver’s seat has damage/wear on the outer edge of the seat, as shown in the photos. I’m looking for someone experienced with car seat upholstery/repairs to repair the damaged area neatly and make it look as close to original as possible. The seat is also heated, so I need the repair to be done carefully without damaging the heating element or wiring. Please only apply if you have experience repairing car seats/upholstery. I can provide photos and more details. Looking for a clean, professional-looking repair rather than a temporary fix.

Mercedes-Benz Sprinter passenger van (Black) Need the front bonnet and bumper re-sprayed due to stone chips and also the plastic gaurd that runs alongside the van, which has previously been sprayed black, needs to be re done as it is peeling in parts due to high pressure cleaning

1954 holden blinkers have stopped working, have replaced flasher unit. Still not working. Wiring is a mess may need rewiring

Car is having a knocking sound when its idle

Hi, I have a 2013 Audi A4 B8.5. I want to remove the current chrome front Audi rings and install a black Audi emblem. The emblem is clipped into the front grille and access from behind is limited. Looking for someone experienced with Audi/VW or car trim work who can remove and replace it without damaging the grille. Location: Revesby NSW 2212 I will provide the black emblem.

I need someone to replace my headlight plastic lens it is broken I have bought the new one

Change glow plugs on my Mazda Bt-50 2006 diesel Glow plugs provided Must be experienced

Hi, I need a qualified mechanic to perform a pre-purchase inspection on a 2009 Subaru Forester thank you .

Hi Aaron, Requesting you a quote to supply and install 4K or any higher definition front and back dash cam for my 2022 Hyundai Palisade. As mentioned, I do have a GKU - D600 front only dash gifted recently which can be used if needed.