Find a local Tasker to inspect your Honda in QLD

We are looking at a Honda accord 2009 in Burpengary tomorrow Sunday at 4.30pm. Hoping someone can check out if it’s ok

I have a 2021 Honda NBox Custom JF4. I purchased a set of Cusco Front Side Power Braces. These: cusco part: 3C6 492 FS. Purchased from https://www.go-parts.com.au/products/cusco-front-side-power-brace-for-honda-n-box-jf3-jf4-3c6-492-fs?srsltid=AU7gw4U1xPxnzouginvRgV4y3atzDYhOx1isDTPIuOwDokOUf7veKzpg Key Installation Points (from product notes and owner reports) • Difficulty: Beginner-friendly bolt-on. • Time: ~30 minutes if jacked up properly (per instructions); 1–1.5 hours with ramps or limited access. Some complete it in under an hour. • Tools: • Car ramps (common and effective) or floor jack + jack stands for safe underbody access. • Socket set (14 mm common; 12 mm long socket helpful for some nuts). • Torque wrench (strongly recommended). • Basic tools for bending the included jig if needed. • Preparation: • Bend the included straight “fixing jig” (固定ジグ / nut-stay style bracket) to match the photos in the instruction sheet before starting. • Remove any standard plates or heat-isolating plates as required for access (noted in product listings). You will need to have the tools

My car won't start (likely start motor issue) and would like to have some professional help replacing the starter motor. I can obtain a working starter motor by myself. I also have roadside assistance that can tow my car to you at your convenience. Please leave an offer if you are open to assisting, thank you!

(Previous task was moderate, idk why) Hi there, I recently purchased a 2005 Honda CR-V (2.4L Engine) from an elderly owner who missed a few services. The car is running sluggishly with no check engine lights, so I want to start by catching up on basic preventative maintenance (PMS) on my driveway in Runcorn or at my workplace in Sherwood. I need a mobile mechanic to bring their own tools to perform the following basic service: * Change Engine Oil & Filter * Replace Spark Plugs (4x) * Inspect Ignition Coils * Clean the Throttle Body & Intake System * Replace Engine Air Filter & Cabin Air Filters * Rear Differential Service: Drain and fill the rear differential. * General Health Check Please let me know if your quote is for labor only (I can buy the parts/oil beforehand) or if you want to supply the parts. Must be a qualified mechanic. Just putting a random amount, but please send me your quote. Thank you for your time🙏 Hope you have a nice day.

I need to fix whining noise coming out the gearbox on Honda CRV 2014. has only done 180,000 km. Not happy to replace the entire gearbox if possible.

Need someone professional to do a complete auto to manual conversion properly. Not interested in a bush mechanic. Have all the parts ready for the manual conversion, would prefer someone who has done it already and has done it correctly.

I have a 2002 Honda AT-V and the A/C is not cold --- RACQ says it is most likely the compressor --- I need it repaired -- You can do it at home -- level under cover area or I can come to you

Basic services and oil changes

Hi, I need a qualified mobile mechanic or auto electrician to replace a leaky external fuel pump on my 1980 Honda Accord (carburetted).The original factory frame-mounted pump under the car is weeping fuel, so I am converting it to a universal, low-pressure inline pump setup. I have already purchased the conversion parts—you just need to bring your tools, standard wiring consumables, and expertise. What I have ready for you: -New PAT EFP-085 (Pierburg) universal low-pressure external fuel pump kit. Premium 8mm ID (SAE J30R9) fuel injection hose. Two (2) brass step-down hose adapters (1/4" to 5/16") to bridge the pump to the car's factory 6mm lines. Four (4) matching metal fuel hose clamps. What you will need to do/bring: Safely drain/pinch lines, unbolt the old leaky external pump from the chassis rail, and mount the new universal pump using its rubber-insulated bracket. Plumb the new pump into the factory lines using the supplied 8mm hose, brass adapters, and clamps. Snip the original factory plug, strip the power/ground wires, and crimp on two small ring/eyelet terminals (please bring these with you) to secure them to the new pump's threaded terminal studs. Heat-shrink the connections to seal them from road grime. Cycle the ignition to prime the carburetor and check thoroughly for leaks under pressure.

I can order the seals when I have checked with the repairer I believe it is a fairly simple job

I need a door replaced - I have the door All you need to do is remove old door and put new door on - I will. Help If necessary

My daughter's 2016 Honda Jazz was T-boned into the rear passenger side. She only has third party insurance so we're looking to get it repaired on a budget that doesn't make it economically unviable. I have tracked down a replacement rear passenger door but the door frame will need some panelbeating since it is a bit bent/warped and the current door is difficult to open/close. So I will supply the replacement door. Quarter panel will also need some panelbeating & paint. We don't need it perfect. Just need it to be roadworthy and touched up enough that it won't rust badly. Fine if paint doesn't 100% match and there are still some small dents visible. Just need the car to be functional really. Job can either be done at our address in Marburg or I'm happy to bring the vehicle to a home/workshop to be done there.

Honda accord euro drivers side window regulator needs replacing. I have the replacement part just need someone to install.

I’m looking for a qualified and experienced mobile mechanic to service my 2019 Honda Odyssey at my home. Location - Crestmead

I have a 2025 Honda Navi I need someone who has done this before and knows how to do the AC to DC conversion for led lights. Thank you

As per add, mechanism does not collapse the back (third row) seats to be folded flat

Need rewiring. Has new main loom and new blinker and tail light assemblies. Wires are there..needs hooking up

The engine was put upside down, does not start Most likely needs new spark I come transport it anywhere to you

I have parts (4 spark plugs) for Honda CRV 2018 .. Need to get these replaced

I have two Honda c90’s needing some light work. This job is for replacing a rear tyre tube on one of them which I have and we can discuss the other work when you arrive.