Find a local Tasker to inspect your Holden in South East Melbourne

I need to remove the old tint for the roadworthy inspection of my 2004 Holden Berlina VY, specifically for the rear window and rear passenger side mirror. Need someone to remove the back carefully because of the demister on the rear window.

Fix central locking key system... car is: Holden caprice 2007 Causing battery to drain out... Even when not running

Needing a starter motor replaced by a mobile mechanic for a Holden commodore omega ve series 2 LPG car.

Hi there Looking for someone to set ignition timing correctly with a timing gun on my holden 308. It has a MSD pro billet distributor (mechanical advance) in it. Cheers

I want to get replaced my cars leaked front axle seal.

Must remove and fit new fuel pump. (New pump purchased by myself)

I need tail shaft centre bearing and strut top bushes and bearings replaced and check engine light investigated on my Holden Commodore Omega 2009

Hi, I need an experienced auto electrician to diagnose and repair an issue with my 2015 Holden Captiva Car only starts when the key fob is placed in the emergency transponder slot. Remote locking/unlocking does not work. Bluetooth, radio, and infotainment system are completely dead (no power). Key battery (CR2032) has already been replaced. Main car battery was tested recently – about 30% life left, but still starts the car fine.

Holden Cruze 2014 1.6L Coolant leaking from water pump needs to be replaced Want to do thermostat and oil cooler at the same time as a preventative Just hit 100,000km so need to do timing belt also

Need to get holden Cruze 2010 front driver side strut replaced. The strut has oil leakage hence need to be replaced. Part is available just need installation , thanks:)

2014 Holden captiva. Hardwire install front and rear cam

Need a registered autoelectrician to Remove my blackvue dash cam from my Holden trax

No I don’t need diagnostic tests, I’ve done it all my self checked fuses with multimeter, checked the suction it is fine. Checked the purge valve over.. I need someone to rewire as the pins with the connector are worn out..

I fixed most common problems with the error code such as purge valve replaced it, the ecm fuse and cleaned the fuel cap.. so I think it might be the wiring/connectors. As I’ve done the rest. Don’t need anyone to go into depth. Just need to see how much it would cost me to do the wiring and connectors.

2 front Wheel bearings need replaced omn holden captiva 2014 model

Just after RWC in narre warren or dandenong south area to be done on my 2006 holden. Haven't registered in 12 months so looking to register the car again.

I have a stock head unit in a Holden Colorado LSX MY20 - Autobarn have sold me what's needed to put an Amp in under my passenger seat, the Amp is for the 4 speakers that are already installed (These have been upgraded already)

Aircon Regass on Holden commodore

Holden Acadia is due for a service , also a transmission service how much will it cost

Need a Holden barina 2013 side mirror replaced. Paint code GAR.