Find a professional patio contractor in Gold Coast

We have a pre-fabricated (kit form) "Flyover" patio to be installed. The patio is 14m X 6m - Due date: Flexible

Looking for a registered builder or carpenter to: 1. Quote replacement of townhouse balcony including frame, decking, balustrade, beams. 2. Quote for replacement of water damage/wood rot on posts of carport/front patio. 3. Quote for repairs associated with ceiling sag in carport See photos 😊 - Due date: Flexible

Patio has empty space because before there was spa but when the spa gone there is big empty space so I would like to extend patio in that space and re paint whole patio. - Due date: Flexible

Wooden beam attaching patio to house needs replacing. Rotten due to water damage. Section of beam approx. 3260mm x 100mm x 40mm. - Due date: Flexible

Need current patio enclosed with glass, windows and doors. Refer pictures. Open to suggestions how best to do this since we already have timber decking. - Due date: Before Sunday, 16 October 2022

Woodwork around pool. 2 garage doors. Wooden patio flooring to be restained.

Shed erection and patio installation, shed is about 12 x 10m and patio 7 x 8m - Due date: Flexible

Patio floor staining. Garage doors to stain. - Due date: Flexible

Total dimensions 5100x6700 Instal shiplap boards (cut down from 5400) to underside of carport/patio. Can be fixed to aluminium with decking screws or suitable alternative. We are open to framing and using exterior vj board otherwise. Please quote labour only we will cover materials

Need a outside patio built decking is down but will be attended to due to renters - Due date: Flexible

Canopia 3000 x 4250 x 3000mm Grey Sierra Twinwall Roof DIY Patio Kit installed on a Granny Flat. Steel frame with colorbond panels. Concrete base. Flexible with installing date.

Need a quote to see what sort of new surface I need putting down ony backyard patio.

We would like our current patio extended and garden area in red (see photos) concreted including under air-con unit. The size of the area to concrete is approx 225cm X 260cm and would need to be level with current patio which can be seen in photos. Access will be through house.

so I have 3 metre aluminium strips/conduit to place around the ceiling under outdoor patio by using sikaflex and with counter sunk nails . At corners will need a hacksaw to cut at angles , I have an apparatus that can line up the strip to be cut at an angle I will supply sikaflex . - Due date: Before Tuesday, 30th Nov 2021

Have a new stratco patio kit to erect. 3mx2m. Very simple job in southport. Flat area single story. Everything supplied. Can help if needed. Should only take a few hours. Only someone with experience. Need done asap

Require a 3m x 5m Stratco DIY Patio structure installed to backyard - must be experianced an have own tools that are required for the install. I have attached pictures of the backyard space as well as the patio install fact sheet. Thank you

Council need a certification on my mums outdoor patio. Need to know cost and if the patio need to be rectified.

Hi and thanks in advance for your reply. Project description: 1. Put together 4 panels & frame kits, which we will purchase shortly. To be installed side by side in front patio of ground floor unit (see one of the pictures in Bunnings link below) a) https://www.bunnings.com.au/matrix-1800-x-900-x-6mm-charcoal-ferns-screen-panel_p0092401 b) https://www.bunnings.com.au/matrix-1815-x-915-x-28mm-charcoal-c-channel-frame-kit_p3041120 2. The new screening must be installed a tad away from the balustrade. Note: our building is currently undergoing exterior repaint including balustrades. See attached image of the front patio. All current screening (fake greenery & grey fence) have already been removed. This new installation will be the only screening in the front patio. The length or width of the patio is approx 3.5 meters, wall to wall with old-style brick pavers flooring. We need to make sure the set-up is very stable as we will put fake boxwood hedges on the other side of the panel (the side facing the unit) for maximum privacy. If I missed something above, since you are the expert, please ask away. Otherwise, please provide best quote, all inclusive. I would also like to know of your plan to tackle the project / approach. The unit is in Surfers Paradise, and we plan to install in 2-3 weeks' time (at this stage depending on the painting progress).

Hi, I have a deck that needs to be drawn up, so I can then have certifier to hopefully sign me off, deck around 16m x 4m

Area cleared ready for new timber/finish to be done