Find an experienced driveway repair contractor in VIC

I need an experienced tradesperson to correctly prepare existing electrical conduits that currently sit on top of the crushed rock base, so the area is ready for concrete pouring. Works required: • Carefully lift and lower existing PVC electrical conduits so they sit below the finished concrete slab level • Provide proper sand or fine crusher dust bedding under the conduits (no sharp aggregate) • Ensure minimum 50–75mm clearance below the concrete slab • Cover conduits with sand (minimum 50mm) before re-instating crushed rock • Re-level and compact the crushed rock base to a clean, even finish suitable for concreting • Ensure conduits are protected from crushing and movement (sleeving if required) Important notes: • This is a driveway slab area and will carry vehicle loads • Conduits must not be visible at finished base level • Work must comply with standard pre-concrete construction practice • Area must be ready for immediate concrete pour once complete

I need to move water pipe close to driveway around 200-300mm to another side. If any licensed plumber can do it please contact me. Thanks

Color concrete driveway, porch, all built area sides approx 110 sqm concrete work

need to repair a damaged and crumbling concrete edge where the garage slab meets the brick driveway (see photo). Ensure a clean, neat join between the concrete slab and brick paving Finish to match existing concrete as closely as possible This is a small repair job, not a full driveway replacement.

Need to unblock the drain in my drive way. It’s about a meter deep.

I would like for someone to move my caravan to my backyard. Probably someone would need a motorized roller.

Location: Clyde North, VIC Description: Looking for an experienced concreter to extend my existing driveway on both sides using exposed aggregate to closely match the current finish. Scope of work: Driveway extension on both sides of existing driveway Left side: approx. 0.75 m x 4.5 m Right side: approx. 3 m x 4 m Some excavation required to prepare base Supply and pour exposed aggregate concrete Combination mix: Daybreak Standard by Boral (or very close match) Acid wash after set Apply clear sealer after completion Clean and tidy site after job Requirements: Proven experience with exposed aggregate driveways Ability to colour-match existing driveway as closely as possible All tools and equipment supplied by you Access is straightforward. Timing is flexible but prefer to complete soon, weather permitting.

I need someone expert to concrete a driveway and pathway at my place. Give us a quote please

Hi there, I need to get a redundant piece of concrete driveway removed from my backyard ideally this week. Please include to cut, remove and dispose of the concrete including cutting and removing the small corner near the entrance to the garage. Sizes are on the photos and it is the red hatched area that needs cutting and removing I need to get this work completed this week, please only price If you can complete this week by Sunday Easy access to rear gate to almost drive up to Thanks

I have a faulty motorised gate to the driveway that needs to be replaced. The doors are misaligned and we want to change it to a sliding gate door and make the gate opening wider. And also we have a garage roller door that doesn’t open properly this needs fixing. Quote please.

Need to move 6 cubic metres of soft fall/play bark from driveway into the backyard and spread around Type of gardening: Other Size of garden: 50m²-150m² Has green waste bin: Yes

Need an experienced tasker to pressure wash, etch, and apply two/three coats of paint or sealer on a concrete surface. Must deliver a clean, even finish and supply own tools and materials (or advise if paint/sealant is needed). Surface size: Standard two car driveway. Looking for reliable, quality workmanship please provide quote and availability.

Power has already been run. Just need a Outdoor GPO supplied and fitted. Existing cable connected to the GPO and then a Female plug supplied and fitted to the other end of the cable.

Need quotes to get driveway concrete repaired. we have an existing concrete crossover. One for the concret blocks roughly 1.5 to 2 mtrs by 1 mtr is damaged and needs replaced. A second block is comparatively less damaged and needs repair or may be replaced.

Task: Pour concrete to extend driveway (match neighbour’s completed driveway) Details: I need an experienced concreter to extend our existing driveway to match the driveway next door (same townhouse layout). My neighbour has already had the job done, and we want the same shape, size, and finish. I’ll attach: • Photos of our driveway • Photos of the neighbour’s driveway (the exact result we want) Approximate Measurements (for quoting): • ~5700 mm on the angle • ~5600 mm straight • ~1400 mm across (Tradie will need to confirm measurements on site.) What’s involved: • Inspect site & confirm measurements • Ground prep and levelling • Formwork to match neighbour’s driveway • Supply and pour concrete • Match the existing colour, height & texture • Clean up after completion What I’m looking for: • Concreter with residential driveway experience • Able to match existing finish • Must supply all materials • Quote for full job (labour + materials) Access to the area is easy. Flexible with timing — sooner is better.

I need someone to paint the driveway. Driveway has already been painted but it has few patches. All driveway to be painted and paint supplied by you.

Removal of dead palm tree branches and leaves. Already cut and placed on our driveway for easy collection. Sharp bits of palm tree branch have been cut off for safer handling.

Repair the driveway as the bricks are cracked or broken

I’ve attempted to install a Milkcan clothesline on my sloping concrete driveway, but I’m struggling to get the post level both ways without using packers that end up showing and making it look really bad. I’d rather have someone professional do it so it looks perfect. • Clothesline posts need to be cut down so the final installed height is approx. recommended height is 1,800mm, but I want • Posts must be securely fixed to the concrete using the supplied mounting plates. • Driveway is on a slope, so everything needs to be leveled properly for a neat finish. Alignment to the roller door needs to look square if you look down it. I’ve already drilled 4 holes for the first plate and put a few screws in so it needs to be fiddled with. Additional Note: I’ve already drilled one hole, but it’s 12mm when it should have been 10mm. The end of a bolt has dropped into that hole. You’ll need a strong magnet (which you can bring) to fish it out. After that, the hole will need to be neatly fixed—either gluing a bolt in place or another suitable method. What’s Provided: • Clothesline, mounting plates, bolts, and standard accessories. What You Need to Bring: • Tools for concrete drilling/fixing • Saw/grinder for trimming posts to the right height • Strong magnet for retrieving the bolt • Any adhesive or filler needed to repair the oversized hole Level to make it square and aligned

Smashed light off driveway wall, needs to be replaced. I will provide the same light