Find a professional bricklayer in West Brisbane

There is a garage wall which needs to be rebuilt and we need to have a support for it as it’s like structural wall.

Need a low brick garden edge built. Approx 60 bricks, 3 courses, curve at each end and approx 4.5 m long. Bricks already on site and lay direct on existing surface. Experienced handyman or bricklayer needed.

Brickwork as part of a small renovation

We’ve just closed in a sliding door and needing to get a brick layer to lay bricks in between our wooden feature and the window. I have bricks as per picture. Bricks will obviously have to be cut to fit the person doing the job. Must provide everything other than the bricks.

need to add two blocks size 400x400 on top of an existing block fence pillar and render it to match the existing render, the existing pillar is 1.4m high which I need to make it 1.8m high

Looking for who can drill four holes in a solid brick wall?112 mm

Space need to be filled up with brick - 2.1m width ( sliding door space, 2.1m height) reduces to 1.5m - 2.4m width ( sliding door space, 2.2m height ) reduces to 1.8m - 2.4m width x 2.2m height reduces to 0.9mx1.2m - 2.1m width ( window space, 0.6m heights) reduced to 0.6m - 0.9m width x 1.2m height reduces to 0.6x0.6 - 2.

The end birck from our side door step has come loose and detached from the other bricks. Need someone to cement it back onto the other bricks.

We replaced a window with French doors. But we now need help to add back in a row of bricks below the sill of the door. Both for aesthetic reasons and to stop water penetration. The area to brick is 2.43m wide and 7.3cm deep. Ideally would like bricks on an angle to shed water, like in the picture of our existing window.

Need a bricklayer to build a South African Braai. Bricks are on site ready to go. To build in two stages, before and after

I currently have two areas of brick where the mortar is cracked and needs repointing. Also have a previous air conditioner area that was filled with brick - that may need replacing due to poor previous work. Holes in brickwork to be filled as well. Looking for a seamless, non noticeable finish for these repairs. If replacement bricks are required - I’m happy to pay for matching bricks separately. One of the mortar cracks is on the second story (below driveway)

Brick fence x 2- besser bricks and breeze blocks. Approx 1.2 - 1.5 high. Lenght - section 1 approx 1.5, section 2 approx 2.6m The hedges in section 2 will be trimmed back to allow space for construction.

Please see attached current photo with garden bed… then how we would like it to look, without garden bed.

Need a neck layer to close an opening with bricks and close 10 small 240mm by 170 mm holes . Door is 700 by 1850

Need brickwork extended about 1.5m X ,2.5m high , single skin face finish both sides . Non load bearing wall , bricks supplied .

A non structural brick wall at the rear of our house was damaged by tree branches in a recent storm and needs to be partially rebuilt with approximately 200 bricks

1. Need the existing fence (timber) being removed and replaced with Brick Fence - about 6 meters 2. In front of the house, about 15 meters, (it’s currently open) I need a fence similar to the photos attached. We will need to leave space open for a carport to be installed later on. I don’t mind what type of bricks used as I would render it later on.

Job involves removing a box air conditioner from the second storey of a house (over 3 metres from ground level); bricking up the hole and making good the inside by infilling the cutout, plastering and applying a single undercoat. Aircon will need to be removed from site.

Letter box coping has come loose (I think the mortar was mixed incorrectly). I have removed and cleaned up the capping bricks and top of mailbox fairly thoroughly. Need an experienced Brickie to replace/repair please. 2 small walls only (1.3m & 3.2m)as shown. There are spares cut and plenty of full bricks required. Two of the top layer of bricks slightly loose also. Happy to pay hourly rate + consumables + travel. I have some basic ladders or a tractor bucket to stand on if needed. Might be good to incorporate some Bondcrete or something into the mortar to waterproof it? Not sure how long this might take, maybe 1-3hrs??

I require a masonry block retaining wall to surround a backyard garden (approximately 10m in length).