Find a professional bricklayer in Perth

I need an experienced bricklayer to repair a painted brick front fence on a corner block in Highgate. The fence was hit by machinery. The corner pier is leaning and has separated from the adjoining wall, and the base along the footpath has gaps with loose and missing bricks and mortar. Scope of work: 1. Inspect the impact damage and check the pier, wall and footings are sound 2. Straighten or rebuild the leaning corner pier and re-secure it to the wall 3. Repin failed mortar and replace loose or damaged bricks 4. Repair the base gaps 5. Repaint all repaired areas, and any other areas needed, to match the existing white finish 6. Clean up and remove all waste Requirements: Proven bricklaying experience (photos of similar work)

Remortar a couple of loose bricks

Pointing required on bricks - additional work available too

We have a finger wall which is needs to be built up to comply with wa pool fence standards. The current wall is 1135mm and we need to raise it to ~1225mm. The finger wall is ~300mm by 195mm. Quite small. We would then need to add a light render to it. So the requirements are to build the wall up about 90mm and render. The job is available to do at anytime from 7am to 7pm. We have plenty of used masonry bricks that can be used but you'll need to cut them to size.

I need to replace some woods stairs that lead up to our front verandah and front door from wood to Brick. Example using AI - a before and an after. I have the bricks, need the old stairs removed - new concrete base set and bricks built.

I'm ready to hire a bricklayer to cut a 39cm x 69cm (0.27 square metres) hole in my front brick wall to fit a letterbox

Looking for an experienced bricklayer to increase the height of an existing brick wall in City Beach, bringing it level with the adjoining wall on the right. Please see attached photo. Approximately 315 additional bricks required (inc cuts), subject to confirming measurements. To include: * Labour, bricks, mortar and necessary materials. * Preparation of the existing wall and proper bonding into adjoining brickwork. * Any removal of screening needed to complete the work. * Protection of existing paving and removal of job waste. Please confirm the existing wall is suitable for the additional height and advise your earliest availability. Looking for a neat, level finish.

Brickwork required for a section of wall

Repair/rebuild damaged low brick garden-bed retaining wall/kerb. Approximately 1–2 metres of the wall has been broken and displaced, with several bricks/concrete sections collapsed onto the footpath. Need damaged sections removed, base repaired and wall rebuilt to match existing. Tree is directly behind the wall, so please inspect for possible root damage. Small repair job — looking for an affordable bricklayer/masonry repairer.”

Add a driveway to front garden, and add a recycled brick wall with spaces for a wooden gate and wooden fence panels. Add a brick wall at back of property with posts for a wooden car gate. Front wall

Brick in one window where a window was removed and two window sides where two windows were resized. Bricks and materials are all supplied and onsite.

Re-lay a few missing bricks to existing perimeter brick fencing (loose bricks are already on site). Pull out 1x old brick bbq and place rubbish in skip bin on site. Pull out 10x old timber infill fence panels and place rubbish in skip bin on site.

I need a piece of wood attached to bricks using a right angle bracket. I have the bracket but not the right screws.

Scope of Work: • Repair brickwork where sections of the fence have started to come away • Ensure the entire fence is structurally sound and visually aligned • Level the top of the fence to achieve a consistent height across its length • Supply and install limestone capping blocks to finish the fence • Optional: Apply a limestone render finish to the entire fence if you offer rendering services Price is negotiable based on the scope completed. Best to agree a price based on a physical viewing.

Angled wall - continue existing wall for 500mm then slight angle to butt into adj wall another 650mm. Floor to ceiling, all materials will be supplied. Pref Sunday.

I need a bricklayer to heighten my existing 4 brick pillars.

I need a loose brick to be fixed back in place. The brick is on the entry steps to the house.

We're getting a custom concrete BBQ put in within the blue rope space (seen in the photos) however before this goes in we need a brick layer to build a one brick deep splash back that runs between both patio posts. Width is about 3m and height is about 1.6m. Straight up against the colourbond fence. A concrete footing will also be required underneath to ensure strength and that its level - this we can include as part of this task or I can get this done beforehand by someone else.

We have had an old arch removed and jingle installed. Just need it rebricked to match the existing bricks below. We have all materials - bricks and mortar.