Find a professional wheel & tyre service in Inner South Melbourne

Minor sun damage (flaking on the top) to my Volvo XC60 steering wheel. Looking to have it repaired so it doesn't get worse.

screw in tyre need to be repaired

Need buckled wheel repaired. Doesn't seem too badly buckled but definitely taken a pothole knock.

Car Tyre Replacement for 2017 Subaru Impreza. - 4 New tyres - Fitting - Take old tyres

My can was hit by a vehicle & the cover over the left wheel needs adjusting as it is pulled away

My car was hit by a van at an interersection . Left hand wheel cover . Looks as if it could be adjusted thanks Margaret

I will need someone to come out to my property in Bentleigh. I need someone ideally with a car jack, jack stands, an impact wrench & professional experience I have a set of 4 wheels that will need to be put on to my toyota crown sedan 1. Take off current set of 4 wheels, 2. Install a different set of 4 wheels onto the car ensuring it is done safely and correctly fitted in a reasonable timeframe. I need this done between monday 29/12 5pm, to tuesday 30th at the most.

Flat tyre on front passenger side. Need help with changing.

Remove old bull bar then replace with new including spotlight wiring

Mitsubishi Triton 2010 Want steering wheel controls connected to Alpine IlX-702D (Aeropro harnesses supplied) I have a light bar on my bullbar that was installed on another car previously. Need indicators on bullbar connected (wiring with blade connectors in good condition) and Lightbar connected. Ive purchased a lightbar harness with the relay and fuse. Plugs for light bar were preserved and still on original harness.

Flat tyre Repair puncture. Supply all material. Mazda cx5 Relatively new tore ~10k kms Caulfield south

Toyota Echo Right hand rear wheel bearing replacement. I can supply parts but please quote based on labour and parts separately so I can make the right choice. I am available Saturday afternoon this weekend or all Saturday from next week onwards. Happy to drive to your garage or place but preferably not too far from Carnegie/Caulfield.

I need to replace the wheel bearings on my boat trailer. Single axle. I will supply the bearings. Labour only.

Replace 4 wheel lugs on a Hyundai iload. I already have the parts. Car is already jacked up with wheel off ready to go.

Have a pice of wire puncturing tyre - is air tight just needs to be removed and a tyre repair needs to occur

4 tyres to be fit on wheels, balancing not required, if available 2 tyres to be balanced. also remove and dispose of two tyres.

I need help replacing my 2011 Mercedes ML drivers side wheel hub/bearing. I have all parts required. Car is located at my factory in Mordialloc.

Job Request: Installation of Wheel Arch Trim and Mud Guard – BMW X1 (2012) I have all the parts. Model 2012 Vehicle Details: Make & Model: BMW X1 Year: 2012 Side: "Front Left" Scope of Work: 1. Installation of Wheel Arch Trim (Fender Flare): Securely install a replacement or aftermarket arch trim above the wheel housing (wheel arch) to restore the vehicle’s original appearance and protect the bodywork. Ensure proper alignment and tight fitment I have the original clips 2. Installation of Mud Guard (Splash Guard): Fit a compatible mud guard behind the same wheel to reduce debris, mud, and water splashes affecting the undercarriage and side body. Ensure the mud guard is securely mounted and does not interfere with wheel motion or suspension components. I have the appropriate screws, bolts, for the installation points.

New tyre needed and to be fitted to a Mazda 3 sedan 2006 model in Carrum

I have another flat tyre on the truck again. Front wheel this time. to replace/repair the front wheel. The nuts are on tight will need crank shift stick or airgun to get off.