Find local power point installers in Inner South West Sydney

Install new PowerPoints, install 2 new light fittings, replace old PowerPoints and check electrical

I am getting a deck built and need a switch installed inside the house with power supply to the deck. The builder will then install and plug to the supply. Also need an existing dome light in stairwell removed and replaced with pendant light.

Replace 4 power points and 1 wall light switch

Move the power points to the left and down. Replace the old sockets and cover up old holes after. One is 15 amp and one is 10amp. (Can use pvc tubes). Located in Revesby and need to be done prior to 8.30am.

A power point need fixing . It’s for the light in the driveway . Also need to add a new sensor light at the front of the house . We will supply the light

Hi, I am looking for a licensed electrician to replace old cotton (VIR) wiring in my house. From what I can see, the cotton wiring is limited to some lighting circuits and a few general power outlets (GPOs). I would like this replaced with modern, compliant cabling (TPS) to meet current safety standards (AS/NZS 3000). Scope of work (approximate): • Inspect existing wiring and confirm extent of cotton cabling • Replace cotton cabling for affected lighting circuits and GPOs • Reconnect to the switchboard and ensure all circuits are safe and tested • Provide compliance certificate at completion Access: • Single-storey home (easy ceiling access and access under the house) with gyprock walls • Job located in Kingsgrove

New single power point on laundry wall. Existing power point nearby on same wall. See photo attached.

Looking for a licensed electrician to help with the following tasks: 1. High Ceiling Light Replacement – Replace an existing high ceiling light with a new paper light fixture (no extra work required apart from the swap). 2. Power Point Upgrade – Change one existing wall power socket to a triple outlet, using surface-mounted conduit for wiring. 3. Dining Area Lighting – Install two pendant lights, powered from the existing ceiling downlight circuit. 4. Bedroom Wall Lights – In each of two bedrooms, install two wall lights (total of 4 wall lights). 5. Relocate Staircase Wall Light – Move the existing wall light near the staircase to a new position. Please bring all necessary tools and provide materials for wiring/conduits as needed. Flexible with timing but would like to complete the work soon.

I want to install two additional power points in two different rooms. One power point per room. The distance between the existing power point to the new one will be around 3 meters

Need a qualified electrician to come and install 2 x power points. Wires have already been run so just need power point installation only

Need external power point weather proof for outdoor stairlift chair to be installed on brick wall as per attached photos, there’s 2 options for wiring could be 17m to the main garage door of the apartment building or 30m around the building to the window of my unit garage in basement (preferred option)

I need to take power from a light switch and connect an extension cord to create an extra outlet

My heater plug is stuck in the power point and won’t come out. The heater was showing as “heated” but it’s no longer working. I need a electrician fix it

cables have been done.just need the power point done

A wall power point start to smoke. I want to change it

Install a power point - you need to supply it which I’ll reimburse separately. Also disconnect sensor

Looking for a licensed electrician to install two power points (GPOs) for heated towel rails — one in each bathroom of a second-floor apartment. 🔧 Task Details: Both bathrooms have tiled walls Power points must comply with AS/NZS 3000 electrical safety standards for wet areas Please use appropriate RCD protection and sealing for wet zones 📍 Property Info: Apartment on second floor (top floor) No direct roof/ceiling cavity access Easy wall access on one side Photos available for reference Location: Bankstown, NSW 2200 Date: Flexible – ideally in the next week Access: Lift access, easy entry Parking: Available

Replace 7 light wall switches. No supply needed Install 4 PowerPoint. Basically connecting the wires. No supply needed. Photo is just an example of where the led strip and some of the wall PowerPoint switches LED strip installation. No supply needed.

Power point switch need to be changed.some time some time not.

Replace two light fittings in living room. In addition the setting up of an outdoor power point