Find a professional pergola installation expert in North West Melbourne

I need somebody to install alumunium single glazed sliding doors on the pergola and enclouse it.measurement 3.5x2.2m left and right side 2.7x2.2-2 front side

old pergola needs to be dismantled - timbers have rotted away and replaced with new timbers and new mesh for the wysteria to grow on there is a wysteria plant that was growing on it - this has been cut back as per pictures attached and new timbers are not supplied - would need to be sourced by the person who does the job. insurance is required.

We have installed a shade in our pergola but it is short from the top by approximately 30 to 40 cm high and 4 meters wide We need that gap closed up , not fussed how or with what materially

We want to enclose the deck area so would like to extend the roof top by a metre. Need a roofer who can install a pergola to extend the roof of our deck sit out so that it can be enclosed.

Need pergola extension to fence. 3 x 4.5 x 1.5m (H x W X L)

I have a pergola which I want to convert to sunroom with sliding doors lockable. Looking for cheap and best option. Partial glass coverage is ok for sunlight. If you have a good plan, you’re welcome. Don’t have big budget.

Pergola has corrugated plastic roof screwed to wooden frame. Looking for someone to remove ~2/3 of the roof and dispose of removed roof. You’ll need your own ladder and drill etc.

Deck width - 281 CM length - 378 CM

Need someone to do paint for front door, garage door, pergola, some bits and pieces around the house. Need a person for one full day. Paint will be provided

Hi guys looking at getting a 2.6 x 2.6 pergola needs to be done by 19th ( This Saturday ) assembled don’t need it drilled into the floor as we’re going to move it so just need it assembled it is a Baltic Manual Freestanding Louvre Roof Aluminium Pergola The link to assemble is : https://cdn.shopify.com/s/files/1/0673/3099/8568/files/Manual_Freestanding_Pergola_2.6.pdf?v=1745283526

Hi I need someone to cut back the corrugated iron roof sheets so that we can access the inside of the gutters for cleaning. The original pergola installer overlapped it onto the roof way too much so we can't clean the gutters. I need it grinded back (including the small plastic laserlite section),so that there's about an inch of access into the gutters. But not grinded too far back or water will be able to get under the pergola when it rains! Thanks

Looking for someone to install pergola roofing that blocks rain and sun with polycarbonate sheets or similar and fix the drainage pipe. Pergola is 7mx5m approx.

Need to remove old ceiling plaster board and replace with a new one in pergola. The measurements are 1400mm x 2800mm.

Looking for someone to reseal the bolts/screws on my pergola roof. Some areas are starting to leak when it rains. Roof is accessible from a ladder. Just need a tidy reseal job to stop leaks.

One transparent plastic sheet of pergola needs either replacement or fixing.

4 posts on Tahiti hut pics 1 and 2 need restumping and a seperate Tahiti hut with decking requires re lifting and straightening pic 3

Need a self supporting frame made to cover the roof area between shed and fence Can be either timber or steel Approx 3m long 1m wide 2m high Need frame with roof covered only for firewood storage

Looking for someone to provide and install pergola roofing that blocks rain and sun such as polycarbonate sheets or similar. Measurements roughly are 9x3 for pergola but this is estimate only. Something similar to attached examples

Build a pergola 4.5 by 5

Erect a flue through corrigated iron roof.