Find a professional hot tub maintenance contractor in QLD

Looking for a licensed electrician to provide a quote and complete electrical works for landscaping (spa, sauna, lightning) at a new home with 3-phase power available. Scope of works: * Install 1 x dedicated 15A outdoor weatherproof power outlet for a hot tub. * Install 1 x dedicated 32A hardwired connection for a sauna. * Install 1 x outdoor double 10A weatherproof power outlet for general use. * Ensure all circuits are appropriately protected and compliant with Australian Standards. * Advise if a sub-board or any additional switchboard works are recommended. Property details: * New residential home. * 3-phase power connected. * All equipment will be located within the same backyard area. * Looking for supply and installation of all required cabling, breakers, isolators and weatherproof fittings. Please provide: * Confirmation that you are a licensed electrician. * Estimated cost (or site inspection if required). * Availability. * Any recommendations based on the above requirements. Photos, plans and equipment specifications can be provided upon request.

Looking for an experienced concreter to construct two reinforced concrete slabs in my backyard: * Slab 1: 2.2m x 2.2m for outdoor sauna (approx. 450kg) * Slab 2: 2.4m x 2.4m for electric hot tub (approx. 2.5 tonnes when filled) * Plain concrete finish * Reinforced and suitable for the loads above * Include site preparation, formwork, reinforcement, concrete supply, pour and finish * Easy backyard access via drive-through garage * Located in Victoria Point, QLD

Got second hand hot tub there's minimal mold on it needs a wipe down set up and chemicals sorted if someone can do this happy to chuck you 180 not much mold at all would take about 30 mins to clean

Qbcc qualified builder required to remove old hot tub that is built into the deck. Then move deck joists to make space opening a little larger to allow new spa. Additionally, I also need the cement slab underneath to be higher. Apologies for but being fully detailed in original task and thank you to those that have enquired.

I have a new cedar hot tub that requires assembly. It is from Shym Saunas. I require two people and they need to have experience in assembling cedar hot tubs

Reconnect drain hose to outdoor spa

I’ve just bought an apartment with a hot tub on the roof terrace that does not have a safety fence. I need someone to install one to meet pool safety requirements so I can get a certificate to rent the place out.

Punctured Bestway Lay-Z-Spa 2.01m x 2.01m x 80cm Maldives MaxHold EnergySense Smart Luxe HydroJet Pro 7 Burgundy Square Inflatable Spa - 6001U

Just had a pool installed and need to move the hot hub

Help to Move a hot tub please

Spa/hot tub removal 8 person hot tub outdoors has been disconnected and out of use for a few years , need gone and disposed of.

Water leaking from under the pump draining the tub

Need hot tub wired up with an isolator switch. 6mm cable already run through roof cavity by previous sparky.

Build Composite Deck – Materials Supplied (Wet Weight 2300kg) We’re looking for a skilled and reliable carpenter or deck builder to construct a composite deck at our property. All materials are supplied and ready to go. Deck Details: • Wet weight: 2300kg • Bearers: 3 x 90mm x 45mm at 600mm centres • Joists: 8 x 140mm x 45mm at 450mm centres • Composite decking boards (supplied) What We Need: • Installation of bearers and joists to spec • Laying and securing of composite deck boards • Must ensure structure is level, safe, and built to Australian standards Location: Redland Bay Date: Flexible but preferably within the next few weeks Please include examples of previous decking work in your response. We look forward to working with someone who takes pride in quality workmanship. Note: there is a small run for water going to the Crain through the middle of the concrete area which is why we need a deck, we need the area to be flat and even to take the weight.

Error 4 thermal trip. I think the circulator pump has failed, as there was a slow water leak from a pump in last few months

To change 5 hot tub spa jets

Paver for hot tub base 2mx2m

In need of someone to come wire in a hot tub. 20m from the mains on the outside wall. Straight line for the wiring from the mains box to the tub. No surface mounting required with the wiring as we want to remove the hot tub in 6 months to the new house. This is what the old owners send me (Normal PowerPoint required, however needs its own circuit - similar to what large Air Cons have. So basically its own PowerPoint running direct from your meter box. Usually electrician just run the cable via conduit direct from power box to spa power point. Just to keep it separate from household power. Hope that helps) Photos attached below Can someone help this weekend ? Send me a price please 🙌🙌

Hi there, I have a round wooden hot tub that has been assembled but it still leaks. The maker has said that to stop the leaks we should use a sealant along every join point on the INSIDE of the tub. Your task is to - assist in cleaning the internal walls - remove the bench seat with our tools so you have better access to all joins - seal the joins (neatly) - put the bench seat back in Attached is an image of the tub and I will provide the correct sealant and materials as advised by the manufacturer. You will be the needed labour! Many thanks!

One working (bypassing broken controller)and one spa not working acquired with intention to fix need removing in preparation for new hot tub arrival. Plug in nothing hardwired.