Find a professional garage door installer in South East Perth

Service garage door. Double sectional door. In good working order, only needs a service.

Install a self closing mechanism (as pictured) on my garage door. I don’t have the mechanism so you’ll have to supply it too please 🙏🏾

Repair two small dents on the garage door and restore the damaged area to match the existing finish. This may include dent removal, filling, sanding, recreating the original textured surface if required, priming, and repainting/blending the repaired sections so they match the rest of the door. The repair should leave the door looking as close as possible to its original condition.

Please give me the quote for new motor or used one?

Garage door has completely come off the rails and is hanging exposing the whole garage and its contents

Need my garage door remotes paired or replaced

Please repair the sectional garage door at our investment property. The door has a large horizontal gap between the middle panels when closed due to faulty/damaged hinges. The panel itself does not require replacement. Scope of work: • Replace the damaged/worn hinges. • Realign the door panels. • Check and adjust the rollers, tracks, and cable tension as required. • Ensure the garage door opens, closes, and seals correctly after the repair. Photos are attached for reference.

Please see attached photo.

Hi, I have a panel-lift garage door that is no longer closing properly and needs urgent repair by an experienced garage door technician. Issues identified: • One of the hinge/joint brackets connecting two door panels has broken — the bracket appears cracked and the bolt assembly is damaged, causing the panels to lose alignment • One of the door rollers (wheels) has come off the track/rail, preventing the door from running smoothly along the guide channel • The door is currently stuck in an open or partially open position and cannot be closed What I need: • Inspect and replace the broken hinge/joint bracket • Re-seat the derailed roller back onto the track • Check all other hinges, rollers, and tracks while on-site to ensure the door is safe and operational • Test the door open/close cycle to confirm everything is working correctly Location: East Cannington, WA

Hi Brian, after the storms, my garage door has been damaged. Could you please inspect it and fix it today or tomorrow?

Urgent Garage Door Repair – Door Misaligned After Storm (South Perth) Looking for an experienced garage door technician to inspect and repair my sectional garage door in South Perth as soon as possible. Following a recent storm, the garage door has become misaligned and is no longer operating correctly. Last night I had to manually force the door closed. The door now appears uneven, with one side sitting lower than the other, and I’m concerned I may not be able to safely open it again. Issues observed: * Door is uneven/misaligned * Door does not close properly * Had to manually close the door * Concerned about possible damage to tracks, cables, rollers, springs or motor alignment * Storm may have caused the issue What I need: * Inspection and diagnosis * Written quote for repair * Repair completed on-site if possible * Advice on whether repair or replacement is the better option (door is approximately 10 years old) Location: South Perth, WA Timing: Urgent – ideally today or tomorrow. Please provide: * Your experience with

My garage door has finally come away from its frame. The door (and maybe the frame) need replacing. I would like someone to come and quote for it and source the parts please (including a new lock / key) Thanks

The Garage Door was fitted 3 yrs back all new . Recently it has started to make a lot of noise. Needs some adjustments and inspection.

I would like a new garage door installed with a motor that comes with remotes. It will have to be a sectional type. Someone that can supply and fit

Need to get Garage Door service.

I brought two remotes and managed to program one of them. I couldnt get the second one to program and now my original remote doesnt work. I am needing someone to come and program the remotes so that I have 3 working.

Fitment of manual roller garage door. I have all the required parts. Size W 2.64 H 2.25

Garage door faulty. Motor is running, but trolley is not pulling the door open/shut

100x100mm SHS Painted Steel Column, weld a 100mm x ~100mm x 6mm Angle Bracket at 3m high on 4 x columns for a lintel to be supported on. Must supply the 4 x steel brackets also.

Hi, I’m looking for an experienced technician to inspect and repair my garage door system. Issue description: When I press the remote control button, the main control unit responds with one or two beeps. However, the chain mechanism does not move, and the door doesn’t open or close automatically. The garage door can still be operated manually by pulling the emergency release cord. What I need: Diagnose the issue, repair or replace faulty parts as needed Ensure the remote control system works properly again Additional info: Power supply appears to be working (unit beeps) No visible obstruction on the track