Find a professional garage door installer in Outer East Melbourne

My garage roller door is making a loud squeaking noise every time it goes up and down. I need someone to come and lubricate the tracks and other moving parts to fix this issue. The door seems to be working fine otherwise, but the noise is very noticeable and I'd like to get it sorted. I have cans of WD-40, degreaser and lubricant, but I think it needs a more professional cleaning and lubrication to properly fix it. Please let me know your availability and if you have the right tools and lubricant for the job.

Garage door chain is broken Need fixing It’s Prolift 230T Not looking for new installation , just need fixing

Cable broke off from spring system.

accidently hitting the door, the bottom steel bar is not straight enough , it could prevent opening properly on the side track. I need someone who could can repair it back to straight line.

I am after a general service of my motorized single gadage door Lubrication of rollers, hinges, and tracks Tightening of hardware Spring tension adjustment Motor & remote check General safety inspection My budget is AUD100.

Lower half of my garage door came off the tracks due to high winds. Need to fix it asap

Garage door needs to come down its locked. Also need remote controls to be set

motorised sectional double garage door hard to open. need to service the tension spring, lubrications etc

Sometimes when I press the remote, the garage door doesn't move and there’s a beeping alarm sound. If I turn off the power and restart it, the issue is temporarily fixed. However, after 24 to 48 hours, it stops working again and I have to reset the power once more. My electric front gate opens when I press the remote, but it makes a creaking or grinding noise and doesn’t open fully. It seems like the motor might be struggling or there could be rust causing resistance

The roller garage door has a metal strip on one side and has come off. This is casing the door to get jammed while opening or closing the garage. The strip was carefully put back in place and the garage shut. The image shows when the garage was fully open. Upon closing the strip of metal was jamming the door.

My garage door motor works fine, it opens and lowers the door. However, when it closes, it stops slightly above the ground, leaving a gap. I need to manually pull it down to fully shut it. The door panel seems to be slightly bent in the middle. I need someone to: • Inspect and realign the panel/track • Adjust or reprogram the motor travel limit if needed • Ensure smooth automatic closing Motor is working normally.

I'm looking to install an electric roller shutter door with remote control for my home parking area. The width of the door should be approximately 3.5 to 3.8 meters, and the height around 2.5 meters. Please let me know if you're available for this job and provide your proposed quote. Thank you!

Fix a dent on garage door

Single car garage 4m width. Top, left side, and right side of the garage door have a gap causing the garage to be very cold in winter. I am wondering if installing garage door seal would improve the energy usage and comfort. I can purchase the recommended materials in advance from Bunnings to save time for the installer and the cost for the job.

The bracket has dislodged from the brick work and the spring came loose. The bracket needs to be fixed back to the wall and spring reattached. The other bracket needs securing as it appears loose.

It needs some adjusting. Doesn’t slide down and go up easily. It keep slipping.

Have the replacement door, it is painted and ready to go. Just need it changed and the handle put on the new door

The door cannot be closed by the electric opener. Seems the bolt is loosen and need to be rectified.

My laundry/garage door latch isn’t lining up there fore not staying locked. I need someone to come and fix it up by Monday afternoon please. I have c a s h only so my offer here is very low.

I have tried doing it myself, but it does not work for me. I need the button to be programmed to work.