Find a professional garage door installer in North East Melbourne

Pop out dent in garage door (cosmetic only, no door operation required) I have a dented garage door panel that I would like straightened from the outside only. The garage is used for storage and the door does not need to open or function afterward. This is purely a cosmetic fix so it looks straight when viewed from outside. The dent runs horizontally across the lower panels. Photos are attached for reference. • No need to open or operate the garage door • No replacement panels required • Aim is to pop out or improve the dent as much as reasonably possible • Finish needs to be visually straight and neat from the outside. Looking for someone experienced with garage doors, panel beating, dent repair, or similar metal panel work.

Good day!I wanted to know if how much is the quote to upgrade a double garage door motor, we only had 1 key functioning left and the company does not supply anymore, we wanted something that we can control using wifi/phone and have the remote at the same time. Thanks location is in Wollert

Adjust spring in garage door

I recently reset my garage door opener, and I need someone to reprogram both the remote controller and the wall-mount transmitter. The transmitters were previously programmed, so there should be no frequency compatibility issues.

Need a motor and installation for my garage door

Garage ceiling needs complete replacement. Makesafe has been put in place to hold the ceiling. Garage size is 5.6x6.0M

Need someone to automate garage door and security shutters so i can access via my phone

I need the Dent out of garage door without replacing the whole thing for my rental property.

Hi there, I need help removing two large metal beams/brackets that were originally part of a garage door system. They’re currently fixed to the wall and floor of my studio/garage. What needs doing: • Remove, and then dispose of two metal beams/brackets attached vertically to the wall, • Both beam have bolts into the concrete floor that I unable to loosen with any tools I have (e.g. adjustable spanner) • The beams also appear firmly secured to the wall • I don’t have the tools to remove these safely. Possible approaches (your call): • Cutting the floor bolt using an angle grinder or reciprocating saw. • Removing or cutting any wall fasteners. • Gently prying the beams off the wall once the fixings are released. • Ensuring the wall is left safe and clear (minor cosmetic damage is fine - this wall will be covered). JOB: • Must bring own tools (grinder, reciprocating saw, metal blades, socket set, pry bar, etc.). • Ideally someone who can also dispose of the metal beams once removed.

Garage door hit by car and panel is broken bottom two

garage door is running inconsistently. sometimes opening half way and wont stay closed. brand is BOSS BOL4

Owner is supplying 2 garage doors Looking for someone to install both garage doors Installation manual will be supplied by owner

We need to install 2 garage doors Owner will supply We just need installation

Garage door put back on roller after hours asap like now

A couple of screwrs have come off my auto garage door. Would like to get it fixed. Photo atrached.

Door it doesn’t work it is brand eco

One side of the garage door cable has come off. Need re-attachment. Plse quote

I need someone to install two Chamberlain single roller door opener and ensure remotes are working. Powerpoints are located on each side of the roller.

Could you please reset my garage door remote? I think it’s an 800N, made by Eco. The house was built in 2013.

Hello, The bottom panel of my garage door is bent after being hit while reversing. The metal support bar on that panel is also slightly bent — it looks like it helps keep the panel in place. Would like to know if anyone can repair or bend it back into place.