Find trusted local electricians in Mango Hill

2 level townhouse, at mango hill. Upstairs • Install 2 powerpoints behind mounted TV's x 2. Downstairs • Install powerpoint in bathroom (need to feed wiring, as nearest powerpoint in corner spot outside toilet under home sign in picture).

Need to change 4 lights (one with fan) to new standard lights from IKEA or so.

Our ceiling will be replaced and will need to disconnect the electrical points such as lights, exhaust fans and smoke alarm. After ceiling has been replaced, the lights, exhaust fans and smoke alarms will be reinstalled. Total of ~32 electrical points. (Combination of lights, exhaust, and smoke alarms.) Note: 9pc of fan w/ lights (provided) will replace 9 existing lights

I am looking for sparky to fix below - Replace two electric point, Replace one down-lights, Repair outdoor fan, Replace outdoor bulb and Replace the cable that connects bulb to small wooden cabinet

I am looking for sparky to fix below - Replace two electric point Replace one down-lights Repair outdoor fan Replace outdoor bulb Replace the cable that connects bulbs to small wooden cabinet

Split system installation needed I can supply aircon

Replace Cross-Flow Fan – Panasonic Split System Air Conditioner I am looking for a qualified/licensed air-conditioning technician to replace the cross-flow fan (the long rotating blower/fan inside the indoor unit) of my Panasonic split-system air conditioner. Air conditioner details: * Brand: Panasonic * Indoor unit model: CS-E15PKR * Part to be replaced: Indoor cross-flow fan / blower fan * I already have the replacement cross-flow fan with me. * No parts supply is required — I only need the technician to remove the existing fan and install the replacement. I am looking for someone experienced with Panasonic split-system indoor units and familiar with removing and reinstalling the cross-flow fan assembly. Please provide your labour/installation quote, including any call-out fee and testing after installation.

I need a quote for a 15amp power point for a portable ev charger to be installed in the garage. A photo of my switchboard and location of the power point will be installed. The main switch board is on the right side of the house and i would like the power point installation in the garage prefrably or any suggestions would be great.

I’m looking for a licensed Queensland electrician to install my supplied 7kW single-phase EV wall charger inside my garage in Mango Hill. The main meter box/switchboard is located at the opposite end of the house, with an estimated cable run of approximately 25–30 metres. There is an existing route previously used for battery DC cabling that may assist with access as the batteries and inverter are also located in the garage, although uncertain if the existing cabling itself can be reused. I would also like four additional standard double power points supplied and installed. Additional images, locations of powerpoints etc can be provided upon request. **Budget is indicative only. I’m open to reasonable, itemised quotes once access, cable routing and compliance requirements are confirmed.

Need new circuit and breaker installed with a 15A socket on the wall in the garage. Approximately 12m cable run from switch board to garage wall. Would like cable gauge large enough it could be upgraded to a 7kw charger in the future

Need some new ceiling lights and need to replace with some light as well i can provide the lights.

Need belt tightened on heat pump dryer

I need 5 airconditioners deep cleaned

One of my house smoke alarms is faulty, it’s going off and I have to take out the battery to stop it. I tried buying new battery but that didn’t work. So I need a qualified professional to fix it.

There are 3 main power points which the boards are broken. I want to get it repair asap.

Need a qualified electrician to help install a skylight calendar (new PowerPoint required) and replace an outdoor ceiling fan. Bonus if qualified for aircon and can look at the aircon unit which currently isn’t working.

Description: I need a licensed electrician to complete the electrical connection for my hot water system. The hot water unit is already supplied and installed (plumbing completed). The job is electrical connection only. Scope of work: Connect the hot water system wiring to the existing electrical supply External hot water system (easy access) No new unit installation required – wiring/connection only

Euromatic ac not feeling cold even though at nights might be low gas please someone look into it

Outdoor unit not starting, likely capacitor.

I need 1 x new wall socket 300mm below current socket (there is a wall socket the other side of the wall). 1 x power socket in the roof area for a rangehood 1 x ceiling fan install (remote control fan).