Find an experienced concreter in QLD

Needing someone to come cut the top of this concrete beam (in between the rollers) so it can be knocked down. We can knock it down just needing the concrete cut done.

Concrete Pool Surround Repair + New Concrete Slab I’m looking for an experienced concreter to complete two related jobs at a property in Brisbane’s western suburbs. 1. Pool surround repair A section of the existing concrete pool surround has dropped/pulled away and requires repair. The concrete appears to have separated/dropped rather than being caused by tree roots. I’m looking for someone who can assess the cause, make it structurally sound and repair/reinstate the affected section. Red Section 2. New concrete slab Construct a new reinforced concrete slab adjacent to the existing area. Green Section Approximate dimensions: - 4.0m × 2.7m = 10.8m² - 5.0m × 3.8m = 19.0m² - Total approximately 30m² - The two areas will form one irregular/one-off shaped slab Good access to the work area. Looking for someone experienced in residential concrete work, slabs and pool surrounds. Ideally someone who can assess the existing problem and recommend the appropriate repair rather than simply patching over it. Budget: $3,500 — happy to consider reasonable quotes following inspection. Please include labour, materials, reinforcement, formwork and finishing in your quote, and provide photos/examples of similar work if possible.

Looking for someone experienced to install approximately 6 metres of drainage along the side of my house. The job will likely involve: * Cutting and removing existing concrete (approx. 6m) * Excavating as required * Installing suitable channel drainage / drainage pipe * Ensuring correct fall for water drainage * Connecting to the existing stormwater system if suitable * Removing waste * Making good / repairing the concrete after installation Please provide a quote including labour and materials.

Repair from.old plumber mistakes Photo available Area is a trench 15m long x0.5 m wide and 8cm deep

Hi, I’m looking for a cover Crete /spraycrete solution to bring my footpath back to life. It’s 7.1 meters long. 930 wide at fence end then towards the top 1250 wide. Theres a section where there was an old step in the concrete as per the pictures

Cut a straight cut 5 to 8 mm wide into concrete along the edge of a wooden deck - 3300 mm long- up to 100 mm depth ( no steel to cut ) Purpose is to separate / isolate concrete slab from the deck Grind high spots & trowel marks off a concrete surface - by 3300 mm by 600 mm - in front of the entrance deck - Leaving a smooth surface suitable for subsequent coating Grind a small area of concrete 600mm by 400 mm & patch 150mm section of an expansion joint- Leaving a smooth surface suitable for subsequent coating

I need someone with a demo saw / concrete saw to cut a notch into a concrete floor at Palm Beach. - Length: approx 2 metres, straight line - Width: approx 50mm - Depth: approx 30mm (deep enough to seat electrical conduit - happy to take your advice on site) - Purpose: laying electrical conduit into the slab Please bring your own saw, blades, water or dust extraction. Wet cutting or dust-controlled cutting preferred, as this is inside a finished space.

I'm looking for an experienced person with a concrete saw to cut a straight line in the concrete alongside my house in Zillmere. Job details: Cut a straight line approximately 11 metres long. The cut needs to be 450 mm (45 cm) from the house wall along the entire length. Cut only – do not remove or demolish the concrete. The cut should go through the concrete down to the soil to allow the concrete to be removed later.

We need to make our side concrete path 25mm narrower to accommodate a new retaining wall. Looking for someone to make a single cut 10m long along the edge of the concrete path. Concrete does not need to be removed, we just need it cut so then we can break it up and remove it.

Had a plumbing leak which has been fixed. I now need a concreter to reinstate the sand tie ins and concrete Slab is approx 500mm x 500mm x 100mm

Cut and remove a concrete slab. 6mx6m x100mm thick with reinforcing. Access to site is through a carport 2.3m high.

Cut and remove excess slab around pool approx 6.5sqm, would like cut to be 100mm or less from pool edge, please see photos, thanks

Looking for someone ASAP this morning to cut concrete and jackhammer 2m of concrete for a toilet relocation. Saw and jackhammer supplied.

Looking to get 60sqm of a 150mm thick concrete driveway cut. I can arrange a concrete skip if required to assist in the disposal or happy for you to manage the disposal.

We have a downpipe that was not connected properly under the pool concreting and is leaking through the house brick wall. Need to cut away the concrete surrounding the downpipe so a plumber can then fix the pipe fitting.

2* 80cm cuts through 125mm concrete

cut existing concrete beside patio/fence • install channel drai • connect into existing backyard stormwater drainage • fix pooling water issueduring rain Have dug put piled dirt from the current drain which flows when the water hits the pipe level in that drain

I need someone with a concrete saw to cut through 2 or 3 concrete post foundations. Foundations are approximately 400mm × 200mm

One concrete cutting 6m long.

I need to core a 150mm-200mm diameter hole in a reinforced concrete slab that is 100mm thick. The hole should be as close as possible to the fence sleeper. The purpose of the hole is to provide an opening to install and 50mm in-ground gate post. The surrounding concrete should not be damaged.