Find a professional local car service in SA

Need to replace handbrake switch of hyundai i30 2019. Went to dealer says expensive because just need to change switch / common problem. Im not experienced to replace it .Happy to pay for labour charge .

Removal old infotainment screen and replacing with aftermarket android touch screen. Also wanting to remove the old cluster and replace with digital. I would do it but have a long term injury. My friend who is in Perth had does this and said the cluster is 5+10i min job and the touch screen about 10-15min. Lots of YouTube videos all colour coded and plug and play.

In Mazda Edwardston. Help to inspect 2019 mazda cx5 maxx sport 2.5i AWD 99,000km

Have a honda accord euro with PLM headers needed to be taken out of car and reinstalled into another honda accord euro. Donor car is already on jackstands with headers unbolted ready to go, but i believe car needs to be jacked up even further to angle it out which I don’t have a jack high enough to do so. Will need a jack that raises higher than 500mm minimum and high sitting jack stands to help. Will need to be from 5:15pm onwards, can be late as possible as I have work till 4:30pm. Job recommended for somewhat experienced mechanics with appropriate high raising jack and jack stands

Pre purchase inspection Kia Sportage 2015 2.4l

Rear main seal gasket Sump seal gasket Have all parts

We have a Hilux 2006 Ute that needs its tub re mounted (after lift removal).

I need my BMW 320i to be regas

The car has a melted/burnt wiring connector (pins 5 & 6) causing an electrical fault. I have already purchased the replacement connector (pigtail harness). The job is to cut off the old damaged plug and properly splice the new connector onto the existing wiring (crimp/solder and heat shrink). Access is already available. Looking for someone experienced with automotive wiring

I need oil change in my Mazda 3 2019

I already have the parts just need someone to fit to my car Holden Commodore VF

I just bought a Uniden x75 Value Pack (CB+Ariel) and need it installed in my second hand 4x4 Mazda BT50 year 2014 model

I have bought new wheel bearing assemblies to go in my mustang but I can't undo 1 axle retaining nut, don't have the tools, I have all parts here ready to go so simple job for someone with right equipment

Remove old radio head. Reconnect wiring for new radio head. Connect new Radio head. Do full test. Car: Ford ranger 2015

Preferably Sat 10 Jan / Sun 11 Jan any time, or weekdays 6pm onwards. I already have the screen installed, just need to connect the reverse camera. Wiring to be hidden. Car is Honda Jazz year 2010

Front Speaker ( driver side and passenger side) fiting in honda civic 2010. I have the speaker but dont have the spacer or cables required. I am going to order and will be delivered next week. If you have the spacer and speaker lead ( cables) let me know . I happy to pay for that Thanks

Replace rear fuel filter between main and secondary fuel tank. I will supply filter. Just need someone to replace that knows what they’re doing.

I have a dent in the rear bumper on my 2012 mazda 6 sedan. I'm in pooraka is this something you can remove?

Install a towbar and wire up