Find an experienced builder in Willetton

Put together a small garden shed

Build approx 1200mm high brick wall and attach it to adjacent wall which was left from removal of a brick postbox and render if possible. We have bricks on site.

I’m building home and need a bricklayer to finish the job - Due date: Flexible

I need Handi Saver Garden shed Installation - Due date: Flexible

Section of concrete drive has lifted causing a trip hazard. Needs to be cut out and replaced at proper leve l.Area is pprox 1500 mm by 1800 mm - Due date: Flexible

Installation of 3.75x0.78x1.95m narrow slider shed (Purchased from Easy Shed) - Due date: Flexible

Want 2 metre width added to existing plain grey concrete driveway. Approx 12 metres long. *Must be licensed/insured.

Need to supply and fix existing roofing which is partly completed. Starting to lean forward a little. Council approvals already done. Wooden decking needs installing. Supply additional decking material. - Due date: Flexible

Face brick demotion needed at quite a few places including removal of old kitchen removal of old fire heater and chimney Removal of few cabinets with material removed from site . Job needed to be done as soon as possible

We have a patio and pergola that need removing. Job requires: * remove colourbond roof * remove timber structure * remove fixings attached to fascias * dispose of all materials The patio area is approximately 4 x 4m with a colourbond roof and the timber pergola area is approximately 3 x 8m. We live in Willetton

Demolition of a 4.5m wide 1.45m high non-structural brick garden feature wall. Removal of bricks included.

We have a job in Innaloo requiring drawing of the plant area and measurements. The system is badly installed. The photos give an idea of what is seen on site. NOTE: Date is nominal. Required by Thursday or Friday this week This task is not to draw all the items installed, as that would not actually be helpful. This is part of a job. The tasker is being requested to: Complete induction allow 1 hour Attend site Measure room correctly including door way Measure and accurately locate all floor slab penetrations only (Wall penetrations can be ignored) with correct pipe sizes Mark up penetrations 1-x with a table for us to populate with functions(once identified) Measure and correctly locate the electrical control boards installed Supply above in CAD and pdf format.

We are converting an aviary to pergola by building a retaining wall max 0.4 m high by 4 m long, paving, reinforcing existing structure to remove a pole in the middle and replace the roof. The area is about 20 m2.

I have just removed a built in shelf and am now looking for someone to help build and install a gyprock retaining wall that is L: 98.3 x W: 106.3 x W: 7.2