Find an experienced builder in Brisbane Market

Qualified block layer needed to build low retaining walls between existing fence for soil retention. Besser blocks. Small job but attention to detail required. Must be qualified, licensed and insured. Start asap.

I need a builder to assist with office expansion while removing walls. - Due date: Flexible

Remove an existing aluminum and glass sliding door Purchase and supply a new aluminum and glass sliding door Fit new aluminum and glass sliding door to demountable office building Remove all waste

I need small area next to my driveway concreted. Budget is just a placeholder please provide quotes.

Chasing someone to redo a small area of driveway 4.8 x 3.4 approx 16m2 - Need the old driveway cut up and removed - The curb cut to make smooth entry into driveway - concrete boxed and poured

5m x 3m shed to be assembled on existing slab. All components delivered. Includes a roller door, window and access door. Previous experience with this type of assembly necessary.

We currently have a 6 by 6 shed we are looking to converting half of this to a open patio and converting the shed to a 3 by 6 shed

Chasing a qualified builder to let me know if the wall marked x can be removed for a kitchen renovation. Will need to pop a roof panel off to gain roof access as older home has no man hole

We need a Shed 3m x 0.78m Narrow Slider Shed from Easy Shed to be assembled.

Install a 3m x 1.9m Easy Shed (model ES-D3019) and bolt to existing concrete slab. We started the installation a while ago but it was more technical than we expected. Some panels are not the correct size and will need to be trimmed. Needs someone very experienced with Easy Shed products.

Require a handyman to trim chicken wire & attach pine frame top & bottom and install in window bays as per photos. Chicken wire & timber supplied bay window areas as follows 1 x 2057mm x 1223mm 1 x 2294mm x 1233mm 1 x 2137mm x 1238mm 1 x 750mm x 1228mm

The pergola is needing to be dismantled by mid March in its current location in Oxley. The components will be placed in a trailer where it will be taken to the Sunshine Coast to be assembled. At this stage, it is only the dismantling that is required however, if the two men who dismantled it in Oxley wanted to assemble it in the Sunshine Coast, that would be a possibility. There will be volunteer supervisory support offered at both sites.

We have a small slim line Absco colorbond shed. L 3000mm x H1950mm x W800mm Concrete Slab already installed

Tree roots have buckled a few slabs of concrete. So, I need this section of the driveway to be flat again.

Looking for 4 palm trees to be cut down above stag horn line and a large tree to be cut down above the stag horn line. Sections to be placed beside driveway for me to cut up. Must have current insurance and ABN number.

Moving 2-3 square meters of gravel from driveway to paths via two sets of 5-6 steps

Need eadyshed assembly . Size 2.25 m X .78X 1.82. to be laid on ground (no concrete slab).

I need a shed installed (3x1.5x2.12). Cement slab will be in place beforehand.

Easy shed 2.25 x 0.7 shed with sliding door needs to be assembled - Due date: Flexible

Internal demolition of a small 2 bed and 1 bath unit incl removal of ceiling and wall sheeting, kitchen cabinets, bathroom fittings and removal of rubbish - Due date: Needs to be done on Monday, 23 October 2023