Find a local Tasker to inspect your BMW in QLD

Supply and fit alternator 1985 BMW 318i Mobile mechanic needed.

Need to replace rear airbag suspension 2017 BMW x5, happy to source recommended part and need them installed professionally?

1 Wiring kit available. Not sure if the rear camera needs a wiring kit as well.

replace handles on BMW 4 series. Replace with new ones that are not sticky. need two doors replaced.

I have a BMW 2010 528i that needs the air conditioner to be regased. The car users 134a gas. I am going to GC on Tuesday 20/1/26 so I would like my car air con regased.

I want ambient lighting in my bmw 3 series, too look like this, and here’s my car

Looking for someone handy to fix a sagging sunroof fabric liner on my car. The fabric itself is in good condition, but the adhesive has failed on one side so it’s now sagging. Ideally looking to have it re-adhered or secured back in place without removing the sunroof unit or dismantling the roof, if possible. Location: Eagle Farm, Brisbane 4009 (near the airport) When: Flexible, weekdays or weekends during business hours preferred Car: 2014 BMW 2 Series 220i The work will be done onsite. We have a large, clean storage warehouse available to work in. You’ll just need to bring your own tools and materials. Photos included. Happy to answer any questions before you accept the task.

The bike sat for a year in the garage for a year and it was serviced all brakes pads done but just sitting there over a long period of time I think the brake fluid needs looking at ?

Needing someone to do front brakes on a 2008 BMW X5 E70 Either mobile or at a workshop within close proximity

I have a 2007 BMW E92 with a front bumper corner that’s sagging. I already have a new bumper and bracket. The bracket is fine, but the bumper isn’t sitting flush with the guard — it may require a custom bracket/fabrication to fix properly. Looking for someone experienced with BMWs or similar cars to: Remove and reinstall the bumper Adjust or fabricate a bracket/mount so the bumper sits correctly Ensure everything is secure so it doesn’t sag again Goal: Clean, factory‑look finish. Paint isn’t needed.

Need someone to install new drive belt on my 2002 BMW 318ti asap

Old bmw e21 with a m20b25 thinking it’s a voltage thing maybe alternator or starter or wiring, my son and I can’t figure it out. Wanting someone to help diagnose please

Remove a windscreen from a BMW X5 F15 - looking for someone who is a specialist in auto glass. Will have future jobs for them as I do dismantling

Reinstall BMW emblem in my car. Front and back and the 4 wheels

I’m looking for an experienced auto electrician or headlight specialist to install OpenThrottle RGB DRL LED modules into my BMW F30 LCI headlights. These modules are direct replacements — no coding required. Job Includes: • Removing both headlights • Opening the headlight housings • Installing the OpenThrottle RGB DRL modules • Clean/safe wiring • Resealing headlights properly to prevent condensation • Testing to ensure everything works and no warning lights appear Requirements: • Experience with headlight opening & resealing • Experience with BMW or similar LED/DRL retrofits • Must bring your own tools • Mobile or workshop is fine (I’m located in Bridgeman Downs)

Need a quote to fix a windscreen for a 2010 BMW

BMW x1 2010 diagnostic test Issue: Car is unable to turn on due to engine start fault. Need someone to run a test and figure out what is wrong with it. Thank you

Hi. My car’s front right headlight has a problem. It goes on and off randomly. It only happens during the day when I have my lights on Automatic setting. The front right headlight goes on and stays on for a few seconds and then turns off. So i switch it to low beams or parking lights and it does the same thing. Stays on for a few seconds and then the front right light turns off. I put it on full headlights and the lights stay on. The BMW service centre has no idea why this is happening either. Can someone help to work out the cause of this problem so it can be fixed? Thanks

2011 BMW X5 35i has an engine misfire fault that sets the engine management into limp mode. Code can be reset, but engine misfires on #4 cylinder under load.

I need an alternator taken out of a car and replaced with another alternator that i already have on hand.