Find experienced auto electricians in WA

Install apple car play in my Honda accord 2012 euro and also reverse camera Note: If you have brand new apple car play screen

I tried to install my new car head unit (Kenwood DMX6523S) into my 2016 Mitsubishi ASX but I realised it was a job out of my scope once I begun. Speakers, radio and Bluetooth all work fine however I need someone to make the steering wheel control buttons work, reverse camera, grounding system and any other features it may have work. I need someone who knows more about it than I do. I have made all connections with heat shrink and by following a pinout i found online. Worked fine for everything besides the aforementioned. Need help getting that finalised. Also need help getting it looking better on the car's dashboard with the fascia.

Car alternator not working - unable to drive vehicle need diagnosis

I have a 2017 Honda Civic and both front headlights need restoration.

Problem: Rear left indicator is not working at all Other functions on the same tail light (brake + running light) are working fine The right side works perfectly Dashboard indicator is hyperflashing (fast blinking), likely due to no signal on the left side What I’ve already done: Swaped the light Installed aftermarket tail lights (LED) Checked connections and wiring visually Identified that the connector clip is damaged, and pins may not be making proper contact There is also a load resistor installed (mounted externally), but unsure if wired correctly

Need to lock/unlock with fob several times to get it to start.

Supply and fit electric brake controller for towing and Anderson from alternator Cost + fee

I have got screen camera and fitments, just need someone to install the camera.

Install rear reverse camera and run new cable to head unit. Both Suzuki swift head unit and camera

Replacing old rear diffuser with new 1. Only few screws under to loosen up. Should be straight forward job.

Title: Car Stereo Installation – Replace Head Unit (Mitsubishi Outlander Year 2015) Description: Hi there, I’m looking for a car stereo installer to replace the existing head unit in my Mitsubishi Outlander with a new Pioneer (model AVH-A245BT) as well as a slimline Sub (model TS-WX140DA). The facia kit is already installed This is a straight swap remove the current head unit and install the new one No custom fabrication required. Located in [Balcatta] Between $140 - $160

Require installation of a DriveVision dash cam (front & rear). Located in Golden Bay, but can drive to most locations South of the River.

I have a Apple CarPlay head unit I need installed in a Mercedes Benz X Class Ute , apparently no modifications are needed should be plug and play with only the gps and microphone cables to be ran through the dash. I require a mobile installer to come to me at my job site as it’s a work Ute , happy to negotiate the price, thanks

Seeking installer with European vehicle installation experience with BMW F30s have complex, high-speed fiber-optic systems (MOST bus); installation experience in NBT (iDrive 4/5/6) systems * Replace current BMW display / head end with New (supplied) Android Auto and CarPlay (NBT) unit ( wired and wireless) * Ensure all New and BMW iDrive original functions are retained and connects to the factory rear camera - iDrive knob should be working properly * Mic - assess and confirm external mic is effective, use of an external microphone with noise-canceling foam, positioned optimally (ceiling center or dashboard) may be required, rather than relying on the unit's internal microphone. * Display unit should sit flush, * Proper Cable Management: BMW dashboards are tight - securely tuck wires away from HVAC vents to prevent rattles and ensure the dash fits back perfectly. * AUX Check: The audio for most F30 CarPlay kits routes through the factory AUX input. Verify that factory AUX port is working perfectly before installing. * GPS/Wi-Fi Antenna Installation: confirm external GPS/Wi-Fi antenna required for wireless connectivity is working Ensure they no laggy or weak connections. * Coding: May require coding (using E-Sys or Bimmercode) to activate features like full-screen CarPlay, optimize screen resolution, or enable the 6CP option. * Clean and professional installation required

I have a xtrons stereo install which is already plugged in and working, however it needs to have the wires hidden behind the dash and run properly all the way to the stereo modules in the rear boot. Reverse camera and microphone also to be installed (supplied by me). Drivers window regulator with replacement clips also needs to be installed (I will supply) as the glass is stuck inside the door. I also have a a new door lock mechanism to replacement the existing which appears to be on its way out. Whilst the door cavity is accessible I also have 6.5 speakers and a Aeropro mounting adapter to replace the factory front door speakers. I also want the trailer electrics hooked up so that I can tow (see photo of trailer module included). I should have all parts on hand by mid February.

I’m after a mobile auto electrician to parasitic current draw test, to find electrical issue and will need to fix too for a Toyota Kluger 2008 and is not drivable atm and I’ve gone thru 3 batteries in 18 mths.

Car stereo installed . . .

I need the plugs on my cars wiring harness changed so they fit into the back of some new headlights that i bought ! As you can see in the photos the one on the right is an OEM headlight and the one on the left is the after market one with different plugs

Hey im hoping there is a mechanic on site? Need my front brake pads replaced and the starter motor replaced. I have the parts and plenty of room to do it. 2005 Holden rodeo single cab chassis 2.4 litre rear wheel drive Thank you

Remove and replace LED headlights