Find trusted car battery replacement experts in QLD

Fault U0100 - lost communication with Ecm/pcm Won’t let me start the car

Hi, I am looking for auto electrician to fix my car wind screen vipers. Mechanic told me to change vipers motor which I replaced but still not working properly. Sometimes works and sometimes doesn’t. Can someone check its electrical side what is causing the issue? Car details are: Haval H6 hybrid 2022

Need an experienced mobile auto electrician or diagnostic mechanic TODAY to resolve a stubborn electrical circuit fault on a 2006 Jeep Cherokee 2.8L CRD Turbo Diesel. The car has been sold with a strict handover deadline on Thursday, so we need a professional on-site urgently. Current Vehicle Status: • Replacement ECM/ECU has been fitted and programmed to the keys by a locksmith (immobiliser/SKIM is 100% fine). • No replacement BCM is fitted yet, though parts are on hand. The original BCM is hanging out for easy testing. • New Crankshaft, Camshaft, and A/C Pressure sensors are installed. • The car cranks over when the Glow Plug Module is disconnected, but will not start. Key Issues to Test/Fix: A fresh scan has thrown two Active fuel circuit codes keeping it locked down: 1. P0190 – Fuel Pressure Sensor Circuit Malfunction 2. P2294 – Fuel Pressure Regulator 2 Control Circuit Open Pins 1 and 3 of the ECU connector are currently missing 12V power (this matches the exact spot where the original ECU trace physically burnt out). I need someone to trace this specific 12V circuit to find the root cause—likely an unplugged connector from the recent sensor installs, a blown primary fuse (Fuse 28 / ASD relay link), a loose earth, or a hard wiring harness short/break. Location: On-site at a locksmith workshop on Tradelink Road, Hillcrest QLD 4118. Looking for a specialist who can bring diagnostic gear down today, test Pins 1 & 3, check the fuel plugs, and bypass/repair the fault. Please quote for immediate attendance!

Looking for a qualified mechanic/auto electrician. Will pay $10 call out fee and willing to pay 30 per hour. Must have own tools.

Drivers side window is stuck down 2023 Haval jolion

Looking for an auto electrician to diagnose trailer lights playing up on left hand indicator signal. Both plugs are new and apear to be wired correctly. could be a voltage issue from truck. need fixed asap to be roadworthy condition please.

Caravan wire connection rusted, needs re -doing

Car audio systems in inop. No music sensors indicators have sound.

Require a dual battery and UHF wired up. Battery system was said to be working when I bought the car but seems to not be charging. Will require someone to look over it and potentially rewire. UFH and new battery will be supplied. Unsure on what the cost will be, so happy to negotiate. Price I have listed isn’t what I’m expecting to pay.

Looking for someone experienced with car electrical work to help with two jobs on my Holden Rodeo 2003: • Diagnose and fix the reverse light, which is currently not working, and make sure the reverse camera works properly when reverse gear is engaged. • Replace/install the cigarette lighter socket. I already have the new replacement part. Looking for someone who can diagnose and fix both issues. Please send me your quote if you can do the job.

I need an autosparky to replace the fuse box in my prado 120 diesel. I will order the fuse box and have it ready. Current one is broken (only the box is cracked, fuses and electrics are fine). Also would love a quote when you’re here for another job fixing the dash lights.

Updated scope – Subaru Outback stereo, reverse camera and battery box installation. I’m supplying all equipment and parts. I have the replacement stereo, auxiliary battery, KickAss battery box and 6-metre battery cable. I’ll purchase the fascia, reverse camera, microphone and required stereo fitting adapters/wiring from Autobarn. Work required: • Remove the existing stereo and install my replacement head unit with the correct fascia and adapters. • Install and connect the reverse camera and microphone. • Connect and test the stereo’s phone/CarPlay functions. • Secure the auxiliary battery and battery box, probably on the passenger side. • Run the supplied cable from the cranking battery to the box, neatly concealed under carpet/trim. • Check the charging/isolation arrangement and fuse protection are suitable, and connect and test the setup. The battery box has built-in outlets, so the previously listed separate 12V sockets and rear Anderson outlet are no longer required. I’ll plug the fridge, fan and phone charging into the box. Please check the supplied equipment before starting and advise if anything else is needed. Any additional costs must be agreed beforehand. Located in Southport. I can bring the car to you locally. Looking for an experienced installer and a tidy, secure finish.

Need an auto electrician to disconnect and removing a fair chunk of wiring, spotlights, antennas, inverter and a bit else. Needs to be fully removed in prep of service body Ute tray being removed.

I have just purchased a new Chevrolet Silverado and need it set up with new electrical plugs to tow by Boss Adventure Hybrid Caravan. I presume would be a straight forward job for somebody who knows this area well.

I Jane the replacement battery but not the tools. Job is to unbolt the old battery and secure new battery in place.

Factory clock and car stereo have completely stopped working in 2009 VE Commodore. It has a pioneer head unit with Aerpro system and the air con is running through this still but can't control any speeds. Initially the steering wheel controls stopped working and then in the last 2 days I've completely lost the clock and radio. Would like this fixed up and the steering wheel controls working again also. Had a mechanic check all the fuses yesterday and couldn't find any faulty fuses so will need some diagnostics run to find the fault he said.

Need an auto electrician to replace connection at the back of light housing in daughter’s car as it has melted and we can’t change the bulb.

Needing a mobile auto electrician to meet at Redbank where van has broken down to repair LDV deliver 9 van Error codes P0341 camshaft position centre A P0340 EGR A insufficient flow P045B EGR B control Since breakdown, fuel and oil has been topped up and camshaft position sensor replaced. happy to discuss and negotiate budget price if you could please note in your offer a rundown of what your quoted amount covers.

Passenger window not going up and central locking not locking passenger door

Unsure on price please make an offer Toyota granvia starting issue Previous starter motor clicked and wouldn’t turn over Installed new battery and starter motor and now car makes no sound when trying to start Unsure if starter relay is faulty or something else Ran fine until this occurred