Find a professional garage door installer in Baulkham Hills & Hawkesbury

Currently we have 2 single garage doors with a pillar in between. Task is to remove the pillar, restore stability, install 1 double garage door.

Looking for an experienced handyman or electrician to install two Meross Smart Garage Door Openers on my existing Doorworks 1200 motors. Scope of Work: Connect 2-wire signal cables to the existing dry-contact push terminals (WALL SWITCH and COM) on top of both motors. Install and neatly route the wired door open/close magnetic sensors along the top rail/tracks. Plug both units into the overhead power points and tidy up the wiring. Important Equipment Note: Garage ceiling is approx 4.4m high, with motors suspended at around 3.8m in the center of the garage (no wall to lean against). You must bring an 8ft (2.4m) or larger freestanding A-frame / double-sided ladder. Location: Baulkham Hills, NSW

Need to make a couple of changes to my garage doors. What I need is the one on the right, I need the motor moved about a metre towards the garage and the chain adjusted to allow the garage door to still open (doesn’t have to open all the way), and then the one on the left I want to remove the motor and the tracks and make it a fixed garage panel which won’t be opened. I’m located at baulkham hills.

Looking for someone experienced in Paintless Dent Repair (PDR) / glue-pull dent removal to repair several dents in an insulated garage door in Norwest. The garage door still works perfectly. I just need the dents improved or removed as much as possible. Because the door is insulated, there is limited access from behind, so I’m looking for someone such as a car dent/PDR specialist who can use glue-pulling tabs, dent lifters, a slide hammer and heat if required to work the dents from the outside. I’m trying to avoid replacing the entire garage door panel. Please refer to the attached photos for the damage. If you have experience with PDR/glue-pull dent removal and think you can improve the dents, please make an offer.

Please repair TWO dents of the garage door (one each door)

Automatic garage door very noisy when moving. More so when closing than opening

I’m looking for someone experienced with garage door repairs to fix several minor dents and dints in my sectional garage door. The door is insulated/double-skinned, and the dents are mainly cosmetic. The garage door still opens and closes normally with no operational issues. Ideally I’m looking for someone who can repair/pull out the dents and improve the appearance without replacing the panels if possible. Please let me know if you have experience repairing dents in insulated garage door panels and what repair method you would recommend. Photos attached showing the damage.

paint garage door exterior,paint available

Install brush seals for garage door with warranty. Double garage door need sealing in all 4 sides to prevent dust from coming in

One of the garage door "brackets" requires 2 pot rivets + rubber strip needs re-fixing at one end See photos

Looking for an experienced garage door technician to repair my automatic garage door. Issue: ● The automatic opener has stopped working over the last 2 days. ● The door opens and closes easily when operated manually, so it doesn’t appear to be jammed. ● The motor/remote isn’t opening the door automatically. Looking for someone with experience repairing garage doors and automatic openers who can troubleshoot the issue and, if possible, fix it on the spot. Please bring any common replacement parts if appropriate (I’ll cover the cost of parts if needed). Located in Rouse Hill NSW. Flexible with times.

Garage door can open, but can not close.It closes a litter bit, then goes back up. double door.

Steel Line Garage door remotes, model ZT07, I have 3 new remotes purchased which needs to be programmed to open the garage doors

Damaged a section of my garage door while reversing my vehicle. Need repair work or a replacement whatever works the best for the damage.

Garage door servicing. It appears that it is slow to close but working. New home built in 2024.

Change residential garage door bottom seals with 5 metre length. The quote should include materials from Bunnings.

Need someone to install the smart garage door controller purchased from Bunnings. Brand is Orion grid connect

Need to repair bottom color bond panel which has bended slightly while reversing car to bottom rollers hold are bend Garage is double garage

I drove my car towards the garage door and it is now deformed, one of the connection fell off. I sometimes have problems in closing it. Looking for something around $500 for service and procurement.

I’m looking for a professional who can do maintenance/service my garage door. It’s a double garage. It’s working fine, but we just want to ensure it will continue to work well in the future as well.