Find a professional garage door installer in Outer East Melbourne

Hi Just move to a new place and last owner didn't pass garage remote. i don't know if this door has ever a remote and it's compatible to add remote.

My garage door motor works fine, it opens and lowers the door. However, when it closes, it stops slightly above the ground, leaving a gap. I need to manually pull it down to fully shut it. The door panel seems to be slightly bent in the middle. I need someone to: • Inspect and realign the panel/track • Adjust or reprogram the motor travel limit if needed • Ensure smooth automatic closing Motor is working normally.

I'm looking to install an electric roller shutter door with remote control for my home parking area. The width of the door should be approximately 3.5 to 3.8 meters, and the height around 2.5 meters. Please let me know if you're available for this job and provide your proposed quote. Thank you!

Fix a dent on garage door

Single car garage 4m width. Top, left side, and right side of the garage door have a gap causing the garage to be very cold in winter. I am wondering if installing garage door seal would improve the energy usage and comfort. I can purchase the recommended materials in advance from Bunnings to save time for the installer and the cost for the job.

The bracket has dislodged from the brick work and the spring came loose. The bracket needs to be fixed back to the wall and spring reattached. The other bracket needs securing as it appears loose.

It needs some adjusting. Doesn’t slide down and go up easily. It keep slipping.

Have the replacement door, it is painted and ready to go. Just need it changed and the handle put on the new door

Garage door chain is broken Need fixing It’s Prolift 230T Not looking for new installation , just need fixing

The door cannot be closed by the electric opener. Seems the bolt is loosen and need to be rectified.

Garage door cannot be opened, looks like the spring may have snapped

The garage door doesn’t roll up. The string attached to the door stuck on the roller. Also might need to get remote control

The panel door is disassembled from the hinges and needs to be reassembled. The 90 bracket is bent which can be purchased or straightened. The rolling door is wire pulley manual.

Repair bend in single garage door and install a new seal. Seal supplied

Squeak Garage door & one roller bracket is broken need to be replaced.

The roller shutter on the garage does not respond to the remote. The motor is working but not responding to the remote

My laundry/garage door latch isn’t lining up there fore not staying locked. I need someone to come and fix it up by Monday afternoon please. I have c a s h only so my offer here is very low.

I have tried doing it myself, but it does not work for me. I need the button to be programmed to work.

Reversed into the garage and a part came undone. Refer to pictures. Need help ASAP

Manual Garage roller door adjustment. When pulled down and closed, it comes back up too far leaving a gap at the bottom. Not sure if its a weather seal issue or a tension issue but the seals look fine. Would like it to sit properly shut against the concrete.