Find a professional garage door installer in Inner South Melbourne

My sectional garage door has stopped working. The cables on both sides have come loose and need to be re wound and adjusted. I need someone to check the drums, shaft and spring tension, then re‑align and balance the door so it operates smoothly again.

I have a single garage panel style door. We are having issues with the chain drive motor. Im looking for someone to either fix the existing unit (Not sure this a go) or source a second hand motor (with 1 remote) and install.

Our garage door spring has exploded out of its original connection that was required to balance and lift the weight the door tilt / electric door opener. The spring had to be fixed in a unique spot due to a concrete plinth being in the way of the original connection point when it was installed. We need someone with expertise and experience in garage door maintenance to re-anchor the existing spring and balance the door to work with the opening mechanism or otherwise provide a working solution to get it lifting again with the electric motor. NOTE: THIS IS A POTENTIALLY DANGEROUS JOB AS THE SPRINGS AND GARAGE DOOR ARE OLD. AS SUCH THE WORKS DONE NEEDS TO BE CARRIED OUT BY SOMEONE EXPERIENCED WITH GARAGE DOOR MAINTENANCE AND CAPABLE OF REANCHORING CORRECTLY INTO MASONRY ETC. PLEASE REVIEW THE PHOTOS AND ASK ANY QUESTIONS ACCORDINGLY.

Inward-swinging wooden garage doors with a gap in the middle. Lookingfora handyman to fix it affordably.

Sagging roof over garage door

Our garage door (timber) is getting so hard to open i think it needs sanding or rehanging it's becoming impossible to open

install garage door opener already have the purchased unit on site. There's already a PowerPoint. Sea attached pictures. Install today.

Just fix the crack in garage door plywood panel fi it neatly pls Crack is roughly 350mmx200

Assess impact from damage Recommend rectification to enable door to open and close Make repairs

wall patch & garage dent repair

Our garage door has some dents and a bit benty, makes it scratches the wall a bit when roll ups/downs. It still functions well and we are just worried the paints got slowly scratched off after long time use. Can anyone fix it? Make the dents less visible is fine. No need to make them completely invisible. But want to make sure the door won’t scratch the wall.

I have a single roller door and a chamberlain DIY motor garage door kit from Bunnings. I need somebody to come and install it for me. There is clearance to install the motor and easy access to the garage from the street + space in the garage. The only thing to note is that the bolts were released while the door was down, so it is not currently rolling up properly which will need to be addressed before installation Thanks

As per photos current door is falling apart so need someone to Supply and Install Primed Door (including installation of door handle with key locks - you'll need to supply but happy to use existing locks from the old door if that will work). It is the side door entry to my garage. Not sure how much it will cost so give me a quote. Looking for a cheap solution / option for a door that I rarely use and do not care about it aestethically. The hinge is coming off the frame as per photos in case that complicates things. Measurements: Approx 82.5 x 204.5 x 4cm

One extension spring on my tilt garage door has fully detached — the spring, anchor bolt, washer and rubber bumper have come off at the top anchor point and the spring is sitting on the floor. The opposite side is intact and working, so there’s a reference to match against. Need someone experienced with garage door springs to: • Supply/match correct anchor hardware (part-thread hex bolt, mudguard washer, nyloc nut) etc • Refit and tension safely, door open/supported • Check the working side too, since springs are a matched-age pair Appears as though the bolt has bent and come loose, spring and frame appear to have no damage. Just needs to be reattached

It won't open, and it looks like the two large springs on the left-hand side have come off. The large bolt that holds the springs in place also appears to have snapped.

Needing someone to fix our electric garage door. Motor whirring is humming, but the chain/belt doesn't move when the button is pressed to open it. Could be an internal drive gear issue needing to be fixed.

General service on a 2 year old double garage door.

Scope Replace old shuttle trolley with new trolley for Garage Door Model: ATA Securalift Garage Door Opener Labour only. Will supply new part. Easy access garage door

garage door cant open. I have remote but it doesn’t work.

Looking for someone to fix our garage door that’s getting stuck while opening in the middle Most likely loose springs or sides Also need to add 2 new remotes