Find local mobile mechanics in New York

Seeking a mobile tire shop or otherwise experienced person to rotate the tires on my Tesla Model Y.

I dropped it while loading it onto my motorcycle carrier today. The shift lever got bent, and the rubber cover over the shift linkage came loose.

Need electric fuel pump replaced.

Clutch plates replaced on Ducati Scrambler 2018 motorcycle.

Trying to get it road ready to ride out cruise the city

50 cc scooter does not accelerate and turns on sometimes .A mechanic is needed to come to where I have the 50cc scooter to repair.

Buying a car at a dealership, car will be ready in about a week. Huyndai 2021, 80,000 miles. Need a guy to come with me to a dealership, do some pre-purchase inspection to see if I should buy this car. Any help with price negotiation is appreciated. I’ll pay you $100 per hour.

Dirt bike triple clamp forks bolt cracked and can’t get it out the clamp

Need 2 new bicycle tires and installed on rims

replace throttle cable on ducati scrambler

just need the throttle cable replaced. i have the new cable.

2002 Suzuki VS800 Intruder — Ignition Troubleshooting — Need Spark Bike cranks strongly but has no spark. Extensive work already completed: New OEM-spec ignition coils installed (3 ohms each — confirmed good) New CDI installed (Denso 32900-38A31 — confirmed getting 12.4V) New stator and pickup coil installed (252 ohms — confirmed good) Main harness O/W wire bypassed with permanent jump wire (confirmed 12.4V at CDI and coils) Pickup coil signal confirmed reaching CDI (Green/Blue wires connected) All fuses good Kill switch and ignition switch confirmed working Remaining issues: Battery dropping to 8V under cranking load — needs strong battery to properly test spark Two black wires (fan/radiator circuit) still unconnected Fan wiring not connected to temperature switch What the mechanic needs to do: Confirm spark with a fully charged strong battery If no spark — verify pickup coil signal strength is sufficient to trigger CDI Connect remaining loose wires All parts are new and on the bike. Previous owner wiring was non-standard — aftermarket ignition switch with British color codes.

The car has a No Start condition—there’s no sound at all when I turn the key, and the gear shifter is stuck in Park. I already scanned the car. It’s throwing code P0685, so there’s an open circuit to the ECM. I’ve already checked the 15A IGP fuse and tried swapping some relays, but the computer is still not getting power. The battery is 100% fine (tested at 14V)

Need somebody that can put a 17 inch tire without damaging anything on a motorcycle Harley 17 inch I got the tire needs to go on the rim

I need help changing my tire

Just need help getting a motorcycle started and possibly help install new battery. Very easy im assuming but will pay someome to do it. Was working fine back in October and sat for the winter. I can start it with a jump but seems to shut off before the engine can really start to idle

I am trying to build an 'ovillanta' mosquito trap out of a tire. It requires cutting two 20" pieces from a tire, drilling a hole in one of the pieces, and glueing a drain into one piece.