Find experienced local carpenters in Texas

Painting and staining these gates. materials will be provided. Must put down masking.

Repair some finish carpentry on kitchen island. Replace some trim pieces. Including touch up paint/stain.

Repair exterior door that came off the hinges

replace hinges and slides in kitchen and bathrooms with soft close

Assemble the following cabinets 1White Shaker Sink Base With Double Doors and False Drawers - 33"W x 34-1/2"H x 24"D 2White Shaker Three Drawer Base - 18"W x 34-1/2"H x 24"D 1White Shaker Three Drawer Base - 21"W x 34-1/2"H x 24"D 1White Shaker Three Drawer Base - 24"W x 34-1/2"H x 24"D 1 White Shaker 42" H Single Door Wall Cabinet - 21"W x 42"H x 12"D 2 White Shaker 42" H Double Door Wall Cabinet - 24"W x 42"H x 12"D 2 White Shaker 42" H Single Door Wall Cabinet - 18"W x 42"H x 12"D 1 White Shaker 15" H Double Door Wall Cabinet - 36"W x 15"H x 12"D 1White Shaker Microwave Wall Cabinet - 30"W x 42"H x 12"D

Needing a wooden door stripped of its current paint, probably sanded a little- whatever it needs to be prepped to be painted/stained. Then need it painted. Both sides.

Im in need of a quote for a attic ladder wood, to be replaced with wood. It's located in the garage.

I need someone to install my cabinet knobs and pulls

Minor renovation to small laundry room (6ft x 6ft) to include: - New cabinet install - Revise shelves, patch drywall and install new shelves - Install recessed light in place of current light - Paint room Additional small project to install crown molding in kitchen

The kitchen cabinet drawer just below my cooktop is stuck. It is probably caved in due to heavy weight.

I need my fence stained front and back it is 10 ft high

I need someone experienced with woodworking tools to assemble a set of woodworking tools. Here is a list of the tools; miter saw with stand, jointer, vac cyclone, router table.

I have a wooden spa mat that needs to be trimmed down by approximately 1/2 inch in order to fit properly in my stand-up shower. Looking for someone with the tools and experience to sand or cut it down cleanly without splitting the wood. Trimming would need to be done on both pieces equally on all side to keep it balanced.

I am flexible about the week of june 13 but need it to be complete by 18 cabinet made of locker material can send pics i have the hard copy of the manual closest manual online is (it is not the same thought but gives an idea) https://manuals.plus/asin/B0F6Y6PLFH

Need someone with wood work experience to cut, place, and stain a wood covering over the gas range hood.

Hi, I want to install wall moulding and accent panel. It's not real wood, it's the pvc one. It's a 48incj panel and need to cut it to 30 inch. so do you have a miter saw? It's easy to cut since not real wood. From the above pic the bottom brown wooden panel and the three moulding on the top. Those moulding are already pre-cut. Just need to stick and screw them proper alignment.

Hello, I need my front entrance wood door stained.

Cut a half circle in a 4x8 piece of plywood

I have a club/bar and I want someone to custom build me some sections seating

Piece of trim fell. 2 ft long. We have intact piece.