Find and experienced emergency locksmith in Melbourne

Hi, I need help unlocking my 1998 Toyota Landcruiser. I have the key but I had to lock the doors from the inside (child lock) and now cant get in as I am also missing the two front door handles. So I just need someone to help me unlock the car. If you have any questions let me know. Preferably this could be done next week from Monday - cheers!

Hi, We are seeking a quotation for inspection and rectification of an electronic access-controlled door at an office suite. The door is the only means of entry and exit for the office, with no alternative emergency exit available. Recently, the access control backup battery failed and the power lead to the control unit became disconnected. As a result, the exit button and PIN pad lost power while the magnetic lock remained engaged, preventing the door from being opened from either side. The backup battery has since been replaced and the door is currently operating. However, the existing system does not have a low-battery alarm, audible warning or manual emergency release to immediately disengage the magnetic lock during a power failure or system malfunction. We require a qualified security, access control or fire systems contractor to provide a quotation for the following: Inspect the complete electronic door access system. Confirm whether the current installation complies with applicable emergency egress and life-safety requirements. Check the operation and fail-safe configuration of the magnetic lock. Supply and install a break-glass emergency release or other compliant manual release device, if required. Supply and install a low-battery alarm or monitoring system. Test and commission the complete system after rectification. Provide a written report confirming the findings, recommended works and compliance status. Advise the expected timeframe for completion.

Lost my key - need to make a new one

Need help unlocking my Mitsubishi 380. The key turns in the driver’s door but doesn’t unlock it, and the remote isn’t working. I also believe the car battery may be flat as there are no lights or electrical response. Looking for someone experienced with vehicle lockouts who can gain entry without causing damage, and if possible, help confirm/jump-start the battery once the car is open.

2013 FIAT 500 key and remote fob need replacing with a newly programmed chip, I still have the physical key and I have the PIN required to program the chip and disable the anti-theft engine immobiliset.

Mercedes Vito Locked and keys have been lost need to be able to move it somehow before council tow Budget set low pending a quote

I don’t have the key for the driver’s side entry door to my vehicle. The battery is flat so I can’t get into the vehicle. Require a locksmith to replace the lock and program key to my vehicle. Ford Ba mk2 xr6

Lost my car key for 2008 hyundi elantra

Locked keys in car. Need a locksmith

Need help fixing my car key remote. The unlock button is not working when pressed, but the lock button and boot/trunk open button are still functioning normally. Looking for someone who can diagnose and repair the issue.

Hi, I need a replacement car key for number 672OD2 Vehicle Identification Number (VIN) JMFXTGM4WSZ013713 Description 2025 MITSUBISHI OUTLANDER WAGON. Need a eta and price, thank you

I have my car, a 2015 mitsubishi ASX, and the key has been acting up. It starts the car normally but distance locking/unlocking is on and off. After I try to re-sync the key it works but as soon as I put it back into the ignition, the fob refuses to work again. I’m guessing I need a new key and the programming needed along. I’m happy to use the same key blade as the one I have right now; it’s an after market anyway. Alternatively, if you could repair the one I already have, I’m all good with that…whatever option is the cheapest. Let me know approximately how much that would cost me…money is a bit tight at the moment.

We need 4 car remote Automatic parking lock barriers re programmed for 10 remotes

Need a key replacement for 2016 Kia Cerato

Installation of 2 x Parking locks at city location carpark . surface mounted into concrete in parking spots .

Found my old car key, but I think my car computer has been configured to not accept it, need this changed. 2012 Honda Jazz Viba

2012 Nissan Maxima Automatic Here are the issues that needs to be fixed: 1. Key fob not working. I’ve already replaced the lithium battery but that didnt solve the issue. 2. Car cranks a little longer than normal only on the first start. It starts smoothly after that, but the issue is there the first time I try to start the car after the cars been off for a few hours.

I’ve lost my keys and need a new one programming for a ford fiesta 2010.

Unfortunately lost my car key and don’t have a spare so need to get a new one.

Old mercedes ignition key circuiyboard needs switchs replaced. I have the parts

The latch on the front gate has broken off due to previous loose mounting and heavy winds blowing it open and shut. While the latch can be screwed or drilled back on (screws have gone missing) it might need a stronger latch/lock.

I want someone to install new lock in my bedroom.

I have a broken lock on a sliding door in an apartment

One side of a lock on my balcony door has broken off and needs to be re-affixed to align with the other half on the other door.. The screws have snapped and new

- The front door security door, no longer locks - The garage side door lockable door handle is very loose and should be replaced - The garage door front door latch is stuck inside the door and the whole door handle should be replaced

Need a lock repaired on a unit

Repair or replace bathroom lock please refer photo - circled part does not engage. West melbourne 3003

The lever handle lock on an internal door has stopped working. It's a privacy-style lock (the round thumbturn above the handle has a red/green indicator). The thumbturn now spins freely in place and no longer engages the latch, so the door can't be locked or unlocked properly. The latch bolt itself and strike plate on the door frame look intact, so this is most likely a worn or broken internal cam/spindle mechanism in the lockset rather than a frame issue. What I need: Diagnose the fault (likely a stripped spindle or broken internal cam in the privacy lock) Repair if possible, or supply and install a replacement lever handle privacy lockset to match the existing hole pattern and finish (brushed stainless/satin nickel lever with round rose) Test that the latch engages properly and the lock/unlock indicator functions correctly

One lock installed, and one lock repaired (or replaced); need locks that can be locked from inside, do not necessarily have to be same handles as photos; looking for cheap job otherwise no need; paying for installation fees and will pay costs of locks on receipts provided

One lock installed, and one lock repaired (or replaced); need locks that can be locked from inside, do not necessarily have to be same; looking for cheap job otherwise no need; paying for installation fees and will pay costs of locks on receipts provided

Same key for both locks on my front door and both are starting to struggle to open it. It takes quite a bit of “jangling”. Issue is same with all my keys for this door.

Doorknob on one side isn’t catching the latch internally and just turns endlessly - therefore meaning the door locks from one side as you can’t engage the latch to open it.

The main door lock works but sometimes it doesn't lock properly, also i noticed that it hard to move clock wise or anticlock wise.

2 x doors open spontaneously, close but a few mins later they open again. Need faulty door lock repaired or replaced

Need help fixing my car key remote. The unlock button is not working when pressed, but the lock button and boot/trunk open button are still functioning normally. Looking for someone who can diagnose and repair the issue.

Need a handyman to come and fix a sliding door lock so that it sits flush, and install a cupboard latch.

We have a troublesome door to an upstairs balcony that needs repair. The lock and now spindle are not turning at all. We tried removing the handle and still can’t turn the handle. Need a locksmith, carpenter or handyman to help me firstly open but ideally also diagnose and fix the door issues because this has happened a few times already before. See attached photos for the mechanism. to access the outside, if we can’t get the door open, you will need a ladder to get onto the balcony. It’s probably about 2.5 off the ground to the balcony, fairly straightforward to access with a ladder but we don’t have one here unfortunately. So please bring a ladder just in case. If it needs new hardware please let me know. I think it’s probably an alignment issue. We are selling the house, ideally today but any time before Wednesday is fine - Wednesday is the next inspection.

I need the lock for my back security door fixed. The bolt trigger isn’t retracting enough to signal release the bolt to slide in. I’d also like a sensor deadbolt/code security lock to replace the existing mechanism on my side gate. Just the ones you can buy from Bunnings. Price excludes materials.

Door lock in an apartment building on collins street - Melb cbd needs fixed. (without breaking the bank) Locks/ unlocks fine. Lever also works perfectly. It’s just coming out a little from the inside - (while fixing it, a small nail was snapped stuck inside - which fits the lock to the door) so it was working like this forever. Need it fixed before i leave for a holiday

I had a smart lock on here that was working fine for months today I went to turn it and it didn't unlock very well... The doors fault bot the smart lock. I noticed that maybe something's come loose or there's something a little crunchy when I open the door and it's not properly opening and closing to the door. For now I've removed my smart lock which is seen in the picture, but still the door handle not opening and releasing the latch remains.... Happy to have a look to see if we can fix it or happy to replace it the handle that is the Smart Lock works fine. Need this today as right now I can't properly close the office so this is pretty urgent.