Find a professional garage door installer in Baulkham Hills & Hawkesbury

Water is leaking between the garage door seal. Need replacement

Need a solid garage door 2200x800x35mm installed with hydraulic soft close due to wind slamming current door which is not solid.

The tention cable on one side has snapped and the door has shifted to one side. The wheels on one side is almost coming out because of that. This happened today in the morning when the door was opened and cant close now. Its a sectional garage door. Photos attached.Budget amount is only to post the job

Motorised Garage door has unspooled and will not move

Merlin Power Ace garage door opener. Need a replacement belt as the old one has torn apart. Second door just needs an adjustment to close level with the remote

I need someone to install automatic garage door opener, ideally one on the photo on my apartment's garage in basement. Pls send your quote

Scope: • Supply and install a tilt-door opener (B&D or Merlin preferred); Wi-Fi/smartphone control preferred; please state if the model includes it • remotes, safety sensors and battery backup • Check springs, pivot arms and door balance Requirements: • Experience with tilt doors and a licence/insurance where applicable • Please state the brand, model and warranty in your offer • Quote any extra repairs separately before starting any work Photo attached. Happy to answer questions.

Reversed my car into the garage door which has created a dent in the middle of the door and the bottom wheel has come of the track (as seen in the picturea with red circle)

automatic garage door chain needs repair

Double garage door opener disconnected from wall two big bolts fallen out

Garage door spring re-tension + opener adjustment - Roller garage door with a Boss belt-drive opener. The door reverses when it hits the floor and stalls halfway on the way up. I've done a balance test: with the opener disconnected, the door drops when released at waist height, so the torsion spring has lost tension. Job: - Re-tension the torsion spring, or replace it if it's past it (quote the spring before fitting) - Reset the opener's travel limits and force settings - Test auto-reverse Must have experience with garage door repairs and proper winding bars.

Currently we have 2 single garage doors with a pillar in between. Task is to remove the pillar, restore stability, install 1 double garage door.

Looking for an experienced handyman or electrician to install two Meross Smart Garage Door Openers on my existing Doorworks 1200 motors. Scope of Work: Connect 2-wire signal cables to the existing dry-contact push terminals (WALL SWITCH and COM) on top of both motors. Install and neatly route the wired door open/close magnetic sensors along the top rail/tracks. Plug both units into the overhead power points and tidy up the wiring. Important Equipment Note: Garage ceiling is approx 4.4m high, with motors suspended at around 3.8m in the center of the garage (no wall to lean against). You must bring an 8ft (2.4m) or larger freestanding A-frame / double-sided ladder. Location: Baulkham Hills, NSW

Looking for someone experienced in Paintless Dent Repair (PDR) / glue-pull dent removal to repair several dents in an insulated garage door in Norwest. The garage door still works perfectly. I just need the dents improved or removed as much as possible. Because the door is insulated, there is limited access from behind, so I’m looking for someone such as a car dent/PDR specialist who can use glue-pulling tabs, dent lifters, a slide hammer and heat if required to work the dents from the outside. I’m trying to avoid replacing the entire garage door panel. Please refer to the attached photos for the damage. If you have experience with PDR/glue-pull dent removal and think you can improve the dents, please make an offer.

Please repair TWO dents of the garage door (one each door)

Automatic garage door very noisy when moving. More so when closing than opening

I’m looking for someone experienced with garage door repairs to fix several minor dents and dints in my sectional garage door. The door is insulated/double-skinned, and the dents are mainly cosmetic. The garage door still opens and closes normally with no operational issues. Ideally I’m looking for someone who can repair/pull out the dents and improve the appearance without replacing the panels if possible. Please let me know if you have experience repairing dents in insulated garage door panels and what repair method you would recommend. Photos attached showing the damage.

Looking for someone experienced with garage door/panel repairs. The damage is small (see attached photo), and I’d like it repaired so it’s as unnoticeable as possible. Please let me know: * if it can be repaired without replacing the panel, * your price, * and when you’re available. Located in St Norwest

paint garage door exterior,paint available

Install brush seals for garage door with warranty. Double garage door need sealing in all 4 sides to prevent dust from coming in