Find a local electronics repairer in TAS

Tea-Towell & Hand Towell strip under kitchen sink broke off. Need to replace strips which hold the towels which slide in and out.

We need some steps built over a steep cement ramp from our driveway to the house.

Take out wooden balcony steps and replace with new one The steps are 2 treads and 1 metre wide roughly step has started to rot due to rain and not upkeeping paintwork

I have 2 lamps with dodgy light switches which I'd like replaced. I have the new switches.

I need to get some concrete steps done in our backyard - approx 5 or 6. Roughly 190 high x 320 long

Take upstairs a Queen Adjustable bed in 2 x boxs & Queen mattress and Installation of the adustable bed

Queen adjustable bed delivered upstairs (easy staircase) and Installed 2 x bed box's approx. 60kg ea. and Queen Mattress approx. 60kg

Electric fault or dirty fuse,? I can burn 70 calories then it stops and goes into error no warning

Need window tinting for my Mitsubishi eclipse cross

-mow front and back yard -patch small hole in wall -paint repairs for minor scratches on walls

needing the stick drift on my ps5 controllers fixed

Auto chair purchased from Harvey Norman-all functioning ok but leg raise stops too low to be effective

Ps5 fell off table, i think hdmi port needs replacing

I have 5 lamps that need new plugs. I had 4 plugs changed in US but they used the wrong plug - see pic. The 5th has a US plug and needs an Australian plug.

Hang a picture in my living room Fill gaps in external brick work, where mortar has fallen out

Need laundry taps moved, under bench top

Need someone to hot swap battery pack into UPS system on site. Will also need to fill out a quick form to confirm task completed.

My NBN box is in garage. I need to run the ethernet cable from the garage to the living room (same floor) via Cat6a cable that supports 10Gbps network.

Here is the specific requirement 1. Network Speed & Cabling: The entire installation must be capable of supporting 10Gbps speeds. Please use Category 6a (Cat6a) or higher specification solid core copper Ethernet cable for all runs. 2. Cabling Runs: Require cable to be run from the existing NBN box location in the garage to the following two locations: * Location 1: Living Room * Location 2: Master Upstairs Bedroom (depending on quote) 3. Wall Outlets (Data Points): Please ensure all wall plates and RJ45 jacks are also Cat6a rated.

I have a leaking Cistern that keeps leaking water into the toilet bowl that needs fixing and 2 taps on bathroom sink

I have 2 lamps that need rewiring. They wires/chords were previously cut.