Find local power point installers in Melbourne Eastern Suburbs

installing 2 * new double power points back-to-back on a standard plasterboard wall -Single-storey house -Tile roof

Need an additional power point behind vanity drawers. Photo shows existing power cable that may be pulled from through back drywall. Plaster dry wall will be repaired later. Please offer with a fixed price. Let me know if you have any questions.

Looking for a licensed electrician to complete the following work at a residential property: 1. Repair an outdoor power point: There are two power points side by side in the front garden. One is working and the other is not. 2. Repair the pool light: The pool light is no longer working. It is controlled by a switch inside the house. 3. Check outdoor power points near the pool equipment: There are several power points near the pool pump and filter area. I’m unsure whether they are working and would like them checked and repaired if necessary. The pool light and the power point issues near the pool equipment may be related. 4. Install two new outdoor power points, possibly three: These locations are close to existing power points inside the house. Please quote for two installations, with the cost of a third as an optional extra. Ready to hire. Please provide your availability and indicate what your quote includes, including labour and materials. Thanks!

I need around 45 down lights replaced from transformer to power point. Please quote me per light. Will need compliance certificate

Need to remove a few PowerPoints on a wall

I am needing help to supply and install a tv wall mounted, install a power point and add an insert plate for cables to run from the tv and down to the tv unit behind the wall.

Double power point installed into pantry

I need an electrician to install a power point on my bedroom wall (ideally recessed) and hang a “43 Samsung tv on the wall. The power fuse box is on the other side of the wall.

Description: Hi, I need a licensed electrician to install one new single power point (GPO) on the wall just outside my under-stair cupboard, for a baby feeding station. • Purpose: To power baby appliances (formula maker, and a kettle). Please make sure the circuit can safely handle the load. • New power point location: On the wall right beside the cupboard door frame, low down above the skirting board (marked in yellow in photo 3). • Possible power source: The blue dashed area in photo 1 is the back of an existing wall plate on the other side of the same wall (bathroom side, near the vanity, see photo 2). Another possible power point, as shown in red (photo 4), may be useful to link to the targeted power point. • Please include all materials and the compliance certificate in your quote. • Access is easy, and there is a plant pot next to the wall that I'll move before you arrive. Please let me know if you need extra photos or measurements. Happy to accept a fixed-price quote based on the photos.

To install a new power point above/diagonal my garage door and to connect the cctv outside the garage to it. The power point will be at edge of ceiling in my garage, you can pull the power supply from existing source in my roof cavity. Drill into a brick next to the new power point to connect & power up a cctv outside my garage.

Install 1 power point in bedroom Install 1 outdoor sensor light

1 in kitchen on ground floor, access under property 1 upstairs in a bedroom/office Maybe one or 2 more still tbc... Licensed electrician.

Replace existing double power point. Both sockets have very loose plug retention. Existing wiring/location unchanged. Please supply and install a standard double GPO. Must be a licensed Victorian electrician and provide Certificate of Electrical Safety.

I am looking for a qualified electrician to help install two smart toilets in two separate bathrooms at my home. Both bathrooms will potentially require a new power point installed. I need to ensure that all electrical work and the final placement comply fully with local government regulations and safety standards. Toilet 1 - B&H Back-to-Wall toilet suite with a TOTO WASHLET requires a waterproof electrical supply. Will need a new powerpoint installed for this toilet located within reach of the WASHLET’s power cord, typically positioned safely outside the splash zone or discreetly routed according to Australian electrical standards Toilet 2 - Caroma Urbane II CleanFlush BTW Toilet Suite (Back Entry). Not sure if powerpoint in bathroom would be suitable. General Help in setting up. Plumber will also be in attendance. Photos below of 2 bathrooms.

Looking for a licensed electrician for 5 small jobs: 1. Power point – Install 1 new power point (wall is currently open – see photo). 2. Bathroom exhaust fans – Reinstall the exhaust fans in the ensuite and powder room that were removed during plastering (existing connections are available). 3. Infrared heater light – Install a new infrared heater light and connect the required switch. 4. Ceiling fan with light – Install a ceiling fan with light in the living room. Existing ceiling connection/wiring is available. 5. Light fittings – Replace the existing basic ceiling lights with new light fittings in 2 rooms (existing wiring/points). Also reconnect/terminate the existing light wiring in 1 bedroom where the light was removed during plastering. All areas are easily accessible – please see photos. Budget: $750 Hawthorn.

Add power point to toilet ( plaster board wall) and replace 2 pendant light fixtures.

I'm looking for licensed electrician to install approx 5 power points in the house. And to replace approx 10-15 downlights. More details: The problem Some downlights don't come on when the switch is flicked — takes two or three cycles to start. Once on, they stay on. Light output across the house is too dim Please check before quoting Whether the startup fault is the fittings or the switches — fix the actual cause rather than replacing everything IC rating and insulation contact on existing fittings Replace any worn switch mechs while you're there Stairs switch only: is there a neutral in that box? What I want Replace downlights(approx 10-15), all fittings in a room done together so colour temperature matches Higher lumen output than current — tell me the output per fitting you're quoting Existing dimmers: leave or remove, whichever is simpler Install approx 5 x 10A power points, including one in the garage — locations marked on site Stairs: optional smart switch, quote separately

Looking for a licensed electrician to carry out a general electrical safety inspection on my newly purchased home in Templestowe, VIC. Scope of work: * Perform a general electrical safety check of the property. * Test all safety switches (RCDs) and inspect the switchboard. * Check power points and lighting circuits for any obvious faults. * Replace 2 × 4-gang power points (supply and install, white standard style). * Replace 1 × light switch cover/faceplate (bathroom) * Advise if any additional electrical issues are identified. Please bring all required parts and include them in your quote where possible. Requirements: * Must be a licensed and insured electrician. * Looking for someone with good reviews and experience with residential electrical work. Please include your total price (including parts and labour) in your offer.

Need to relocate a light switch & move 3 power points ready for plasterer.