Find an experienced concreter in QLD

Cut relief joints on pool surrounds

Handrails between front porch posts have rotted out. Need replacement. Would like to be replaced, and then repaint, including repainting the remaining porch. Two sides of the porch, with one being about 1m long and the other about 1.5m long.

Need to repair concrete cutter and jack hammer

Just need a small area of concrete layed under a clothes line

Driveway resurface had cracked and needs to be ground off and polished

Need a path done approx 30 square mtrs plumbing will be done just need path dobe

“Hi, I need plain concrete laid in my backyard, approximately 6sqm. There is easy access to the backyard. Looking to get it done as soon as possible.

This used to be a small rock wall with pavers on the top. We need the remaining concrete jack hammered out. I don’t think the concrete goes in very deep at all. But just need it broken up and we can remove the concrete. We tried with a 7kg jack hammer but had trouble with this last bit.

Need help backfilling retaining wall. 600mm high by approx 21m long. Should only take a few hours. Tools provided. Wall being built today

Cut 100 - 120mm off 4x Concrete Sleepers 9inch grinder required Please send offers

I have a piece of metal protruding from some concrete sleepers. 5mm thick metal about 9cm long. Quick 2minute job with the right tool.

I am looking for a experience concrete resurfacer for a drive way of 30 meters lond and 3 meters width.

Cut core filled block wall approximately 4m long 1m high into manageable sections to be removed. Ring saw required. Cash paid.

Looking for someone with a jackhammer who can clean up the edge along the slab in preparation for a new concrete spoon drain to be installed. We have removed the previous drain but need the edges cleaned up. So bit of jackhammering, bit of shoveling. Happy to agree on hourly rate.

Hi, I am looking for someone to deliver 25 concrete sleepers from Pimpama to Algester.

Dig out trench only 4 metres long. 4 inch deep. Half done already. Level to lay blocks.

4m2 section of concrete. Needs to be cut and removed. New slab laid and pinned to the existing driveway. It’s currently sinking a few centimetres and water is running under the concrete. Note: metal stair stringer joins concrete at the bottom and will need to be reset to the concrete.

Cut 5 concrete sleepers and I’ll help you lift them into the posts Need a concrete cutter

I’ve recently poured mortar / concrete (and painted over it) into a channel at the base of my raised garden beds and water has started to pool as there’s no longer any drainage. So I’m wanting to get it broken up and removed. Should be doable with a hammer drill, small jackhammer and/or a concrete saw. The mortar/concrete is only about 5cm thick/deep and is 10cm wide and 15m long. Once you’ve dug up the mortar I want you to remove a further 20cm of the dirt below it so that I can install a drain and gravel. Photos attached showing measurements.