Find a cladding professional in NSW

Joineries on the 2nd floor of our house appear to be loose/sliding out. Will need someone who has a high enough ladder and experience to come in and fix it. Issue is from 2 sides of the house. Majority is at the back of the house where the first floor roof can be used to reach it The 2nd side is on my neighbors side, and a higher ladder is needed, as it will need to come over the fence in between my neighbor and our house

1. I have materials and battens have been installed on one side 2. Need cladding to be done in Trimdeck 3. Just labour

Remove old coating from cedar cladding on house and clean timber ready for recoating.

Install (6) solar lights on cladding (drill in) And hang up festoon lights (60m) zig zag (plug in).

Measurements for my wall are as follows (photo attached is numbered 1,2 and 3). The slats will need to be cut down a few millimetres. I have ordered the slats, will arrive in a week or so. 1. 2650mm high x 4270mm wide 2. 2650mm high x 610mm wide  3. 2650mm high x 250mm wide  Please note the largest wall (number 1) is a concrete wall so it will need batons behind the cladding. Link to the cladding I’m using is here. https://woodspace.com.au/products/teak-outdoor-cladding You must have all tools for this project.

One external clad wall.. 1 x Undercoat / primer 2x Paint coat All white including window frames. Approx 13M long & 2.3M high. We will provide the paint. Need finished by Thursday 2 April.

- Cladding repair ( mild damage , no replacement needed atm) - outside house paint + gutter +eaves - open to all quote

Need a reliable airtasker to supply and install wall cladding (wpc timber look, attached photo of product). Feel free to add removing of the existing shelving to your quote, but im also happy to remove it myself. Dimensions are shown in the photo attached. I have attached an example photo for the reference. Location leppington

Looking to get external cladding repaired, the space is approximately a 1.5M x 2M area. Keen to get this done ASAP. Happy to get some pricing. It's grey panelling. just looking to get it replaced. Damaged due to wind.

External cladding to go up at front of the house

Labour including glue for three columns to be clad in Flagstone assorted shaped stones, per square metre rate only

Stone cladding walll 3 X 2 mtr kingsgrove area.

looking for handymen to install wall cladding and shelves

We have just had a fence built and we would like castellation cladding put in front of 2 boundary fences 5m by 2.5 high and 4m by 2.8 height

Handyman or carpenter to help put internal cladding (v-line) board: - on 2 walls in a garage - on roof over decking

PRICING NEGOTIABLE . Paint Exterior- Vinyl cladding house - Single level + primed exterior timber rail + timber undercroft ( under construction finishing Sunday).No need to paint window trims. PRICING NEGOTIABLE . Thx

Need cladding boards painted, and gaps around the window sealed with no more gaps and painted aswell, I have the paint, window are on the second story about 4meters up, extension ladder is available aswell

Must remove cladding, foam and removal all nails or nail them into the wall. Must be tomorrow. Scissor lift provided onsite

Remove 2 broken colorbond cladding panels and replace with new ones. I can supply material or reimburse cost of materials + labour. Each panel is around 2metres or so and is the light cladding ones not the heavier colorbond steel that surround them.

I've got all the materials. Just need so eone with good attention to detail to sand back, the lacquer the blackbutt interlock wall cladding at the front of our house.