Find a cladding professional in QLD

We have removed a small amount of timber battens from our blueboard exterior wall. These exposed strips need sealing for weather proofing. We would then like 6mm FC cladding installed 2870 high x 1770 wide (fire clearance for solar batteries being installed). And sealing new edges. Other fire approved materials for covering exposed areas where timber battens were would also be considered. We would also be interested in it being painted but not necessary. All material to be supplied and delivered by contractor.

Needs a stone cladding done, Just at the front (not required where the water stays) Highlighted with green I have already built a body, Might need bit of rendering as brick laying has not been perfectly aligned Measurements Width-2.6m Height 1.8m(mid section)(highest point) Stone measures 227 mm 100mm Stones might needs cutting to bring perfect ending I have ordered 4.8m2 of them

We are looking for an experienced installer to install wall cladding at a residential property in Burpengary East. Job Details: • Wall cladding: approximately 20 pieces • Wall size: 10 ft 5 in (width) x 7 ft 5 in (height) • Materials will be supplied If you have experience with wall cladding installation and are available for this job, please get in touch with your availability and a quote.

Hello, We require an URGENT call-out from an experienced shopfitter, carpenter, or cladding installer to inspect and secure a piece of our external signage in Logan Hyperdome. The Issue: A section of the cladding panel on our main shopfront sign (located behind the "Oscar Wylee" lettering) has come loose and fallen forward, resting against the 3D letters. This is a significant public safety hazard, as there is a risk the panel or the signage letters could fall. The Job: The task is to attend the site urgently, assess the signage, and securely re-fasten the loose cladding panel. The scope of work includes: 1. Safely accessing the high bulkhead signage (a suitable ladder/platform will be required). 2. Inspecting the loose panel and the frame to determine why it failed. 3. Securely re-installing the panel using appropriate and durable fixings (e.g., screws, adhesive, new clips) to ensure it cannot come loose again. 4. Inspecting the security of the adjacent panels and the main "Oscar Wylee" letters to ensure they are not also at risk of falling. 5. Leaving the area safe and the signage looking professionally finished. Requirements: - MUST have proven experience with commercial shopfitting, signage installation, or cladding. - You must have your own tools, including an appropriate ladder or platform to safely work at height in a shopping centre. - You must supply all necessary materials for a secure, permanent fix (e.g., screws, construction adhesive, brackets). - Public liability insurance is required. Location & Timing: Location: Hyperdome Shopping Center Pacific Highway &, Bryants Rd, Loganholme QLD 4129 When: URGENT - We require this inspection and repair to be completed as soon as possible. Please state your earliest availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include your call-out fee, all labour, and the cost of supplying all required materials for the repair. Thank you.

Cladding a house that has partial cladding

Cement sheets to be installed over existing lower level wall. Will need cutting/measuring and adhering. I’ll be able to help where I can also. Works needed for pre water tanks instillation. Materials and some tools available and happy to prep and grab anything needed for the job.

Hello! Looking for a carpenter as we need to close in two open sides of our garage (currently timber lattice) to make it fully enclosed and waterproof. We’re after a clean finish similar to neighbour’s cream cladding (see photos). Some timber beams look water-damaged/rotted and may need removed or replacement also (photo attached). Walls approx: • Back: 2500mm W x 1930mm H • Side: 3200mm W x 1870mm H Quote to measure everything up, and include materials + labour. Open to advice on best fix.

I have ordered bendy cladding see photos one stuck on top of the moulding 12 mtrs just needs to be cut to height

Where the ply is I need new weather boards doesn’t need to be timber Under ply is studs . Ply only there temporary Area is 3.6 x 3.6

Looking for a chippy / handyman to hand a plywood sheet up against a Linea Boars clad exterior wall so i can mount a dart board. Materials provided - ply and timber braces with screws. Just need somebody to do the hard work.

Singular peice of cladding has started pertruding from the wall. Need it screwed back down

On the back wall of the house (the side facing the patio), the horizontal joints between the external cladding panels are not aligned properly. Starting from the right-hand side (near the downpipe corner), the joint lines gradually move downward as they extend to the left — across four sections of panels

Internal tv unit wall cladding and external facade wall cladding.

1980's high-set house requires downstairs back wall to be re-sheeted using fibre cement sheets to span over 11mx2.4m area. Existing wall contains 6.6mx2.4m asbestos (confirmed) sheeting with pipe connections to hot water system; upstairs/downstairs toilet piping; two windows; one doorway. Other sides of house already completed as part of a recent renovation. New sheets need to match textured paint. Downstairs outside area will be mostly cleared for worksite.

Demolition and Removal of feature wall cladding in Office boardroom. The cladding is 'stuck' on decorative foam and will remove easily.

I need a skilled handyman or renderer to repair the stone cladding on a garage pillar. Scope of work • Rebuild or patch the base where needed • Reattach existing stone pieces if possible • Supply and install matching stone if any pieces cannot be reused • Make the finish neat and consistent with the surrounding façade

As part of a team, and working on 4 metre scaffold. Remove vinyl cladding, de-nail weatherboard walls, sand and prep, undercoat and paint.

Hi, I’m looking for an experienced cladding installer or carpenter or cabinet maker to build a custom modern TV feature wall in my living room. Scope of work includes: Installing acoustics cladding panels on the the TV wall (floor to ceiling). Size 4200/2700 Creating a built-in tv until

Need 2 labourers to help lift some external cement sheet external cladding

Fit and supply external james hardie cladding to front gable.