Find an experienced cabinet maker in Potts Point

I need a qualified Cabinet maker to cut and install a space for a slim dishwasher. - The dishwasher will be installed on the left in the images below. - Dimensions of the dishwasher as here: Height: 815mm - 875mm, Width: 448 mm, Depth: 575 mm - Width between the sink bowl and the wall is 460mm. Height between the floor and underside of the cabinet top is 865mm. Depth to the front of the cabinet is 500mm. I'm expecting that the dishwasher will stick out 75mm at the front, which is ok. - Work will involve: Removing the left door, cutting away the cabinet floor and skirting board, cutting the left side of the cabinet, removing the top railing on the left side, and add any required supports for the remaining cabinet and counter top. If you have any questions about the job let me know. - Due date: Flexible

I need a desk/hutch built, specifically so that I can close and hide the desk. Either white or ash wooden type

I am looking into getting built a simple bookcase/shelf to be built. Approx 150cm x 40cm x 40cm. Split into 3 sections. Using plywood with white laminate with edges cut. Happy to pay extra for delivery.

Need someone with good carpentry and or cabinet making skills to assist. First task is to swap position of Cot bed and Kallax cube storage unit as opposite of current. The Kallax cube storage unit consists of 2 parts, a [Content Moderated] x 4 cube), and a 77 x 144 unit (4 cube). The 147 x 147 unit needs to be disassembled and customed to add 2 keyboard sliding trays (similar to computer keyboard slide but wider). This can be achieve by using drawer slides and cutting a piece of melamine to fit the width of the unit. 2 drawers are required (one for music keyboard, and the other should fit a computer keyboard). This should be at a height of 70+ cm for each of the drawers. The cube section may need some strengthening for this. The current Drawers and Doors will need to be refitted into the customised structure in different locations (to suit). Finally the 4 cube section will need to be cut down to fit in the smaller space. I expect it will be slightly less then 4 cubes wide.