Hire a trusted bathroom cabinet maker in Melbourne

Assembling and installing kitchen & bathroom cabinets (including cut & put in the substrate sheet for the bench-top) ; Need couple of cabinets trimming and a door hinge holes drilling. Installation plan will be supplied. Putting back existing laundry doors in the bathroom after trimming the height of the doors. Take away rubbish. Work insurance is required. No weekend work. Need to work together with plumber and electrician to complete the job. Please refer to the design plan below for reference.

What I need done 1. Kitchen  - Install panels in existing cavity  and build cabinet doors in existing kitchen as shown in the picture below - Build and install white cabinet frame and doors ( white  non gloss) -Measurements for open cavity in the kitchen as per the picture below     Width x 81cm Depth x 58cm Height x 50.5cm 2. Bathroom a) Install Panels  in the existing open cavity b) build and install cabinet door to existing shelving( white non gloss - Measurements  for existing shelving Width x 155    Depth x 45 cm    Height x 48 cm c. Build and Install shelves and cabinet doors ( white non gloss) Width x 155    Depth x 45 cm    Height x 45 cm

Want to replace the the bathroom cabinet and light covering currently on the wall near basin - please see attached. Mirror cover 85 x 15 x 15.5 Cabinet 52 x 60 x 14 but want to reduce depth No mirror needed on the cabinet door, just a standard laminate cabinet. Colour TBC - probably cream/white.

I need someone to make me a MDF cabinet with a door to sit in the wall of my bathroom. It is aprox 440 wide and 900 long. I would love it done by late next week.

Looking for a bathroom cabinet to be 860 x960 wide X 550 deep Needs doors but no top or basin

The bathroom cabinets are half completed. It requires counter top and shelves. Doors are there but needs kickboard and shelves. Need two doors to bathroom and toilet replaced . Various other painting required in unit. Costs must be based on quote after site inspection.

I need an under-sink bathroom cabinet to be assembled. I have already started to assemble it as shown in the photo. The job will require screwing, hammering and drilling. I would also like two areas on the top of the cabinet to be sawed off to allow space for two water pipes so I can position the cabinet against the wall (also pictured). Additionally, I would like a shelf to be installed in the cabinet. Ideally the same material (chipboard) and colour (grey) but I’m not too fussed about this.

Replacement of a cabinet mirrored door