Find a professional pergola installation expert in Outer East Melbourne

Remove and replace approx 55 sq metres laserlite / polycarbonate pergola. Like for like replacement (existing sheets are damaged by lichen). Ideally you can also arrange supply of materials or specify what's required. There is no flashing or pointing to remove or replace. Existing timber to be reused. Take away all rubbish.

🔨 Build Gable Roof Steel Pergola – 7.7m x 6.0m Pricing is just set so you can come visit the site and give full quote! 📍 Ferntree Gully, VIC Looking for an experienced installer or builder to replace our current flat-roof pergola with a new steel-framed gable roof version. It will attach to the fascia of a single-storey brick home — no posts required at the house. Deck and layout stay the same. Specs: • 7.7m wide x 6.0m deep • Gable roof (22.5° pitch) • 2.4m high at fascia, 3.83m at ridge • 3x front steel posts (100x100 RHS) • Rear beam (150x100x4.0 RHS) fascia-mounted into rafters Connection: • Use fascia support brackets (into rafters, not just fascia) • Flashing + tile lifting required • Must be sealed/weatherproof Materials: Want it built using (or equivalent): • 3mm galvinised steel posts/beams • Fascia brackets • Colorbond roofing • Apron flashing + sealant We can supply materials or happy for you to quote including them. Job Includes: • Install fascia brackets + rear beam • Frame gable roof and install front posts • Flashing and waterproofing • Structure must support ceiling fan/heaters Quoted price here is flexible — open to quotes. 📸 Pics show current setup (flat pergola) and what we’re after

🔨 Build Gable Roof Steel Pergola – 7.7m x 6.0m 📍 Ferntree Gully, VIC Looking for an experienced installer or builder to replace our current flat-roof pergola with a new steel-framed gable roof version. It will attach to the fascia of a single-storey brick home — no posts required at the house. Deck and layout stay the same. Specs: • 7.7m wide x 6.0m deep • Gable roof (22.5° pitch) • 2.4m high at fascia, 3.83m at ridge • 3x front steel posts (100x100 RHS) • Rear beam (150x100x4.0 RHS) fascia-mounted into rafters Connection: • Use fascia support brackets (into rafters, not just fascia) • Flashing + tile lifting required • Must be sealed/weatherproof Materials: Want it built using (or equivalent): • 3mm galvinised steel posts/beams • Fascia brackets • Colorbond roofing • Apron flashing + sealant We can supply materials or happy for you to quote including them. Job Includes: • Install fascia brackets + rear beam • Frame gable roof and install front posts • Flashing and waterproofing • Structure must support ceiling fan/heaters Quoted price here is flexible — open to quotes. 📸 Pics show current setup (flat pergola) and what we’re after

We need someone today from this morning to paint the underside of pergola. 1 x coat, no sanding. Paint is here and ready to go. There are 9 rafters, about 8 metres of eaves sheeting, 3 posts, battons and a fascia board. need it done today 14/06

Hi there, I'm looking for a steel fabricator or handyman to help build a minimalist open-frame pergola in my backyard. Inspired by the style in the attached images, I’d like something simple, modern, and vine-ready (no roof/sheeting). Design & Specs: Size: 2.5m wide x 11m long Material: Steel or Aluminium (preferably galvanised or weathered/rust-effect) Structure: Posts and rafters only – open on top for climbing plants or fabric Must be fixed securely to ground (concrete footing or bolted base plates) Optional: mesh, wire, or bar lattice for plant support on top Budget: Looking to keep total cost (materials + labour) under $2,000, open to advice on how to simplify if needed

Paint 2 external pergola’s First pergola is 3.5m x 4m Second pergola is 4.2m x 6m Paint provided

I'm wanting to build a pergola but need a building surveyor to help with permits. Located in Maroondah council.

I need a chippy to dismantle a pergola. 4m wide, 10m long. I'm going to be transporting the pergola to my house to reinstall, so i can't have any damage to the pergola.

Looking for an experienced carpenter or handyman to assess and either repair or completely rebuild an outdoor timber pergola at my home in Boronia (3155). Size: Approx. 5m x 4m Structure: 3 timber posts, attached to an outdoor roof section Roofing: Clear corrugated plastic Issue: Timber posts and beams have visible rot and structural damage. The structure is unsafe in sections. Access: Through standard garage door, leads to a paved area Materials & Cleanup: You’ll need to supply all materials and remove all waste I'm open to: Repairing structurally sound sections (if possible) Or tearing down and rebuilding to match the existing layout Budget: $2000 total (materials + labour) — happy to discuss depending on scope

I am intending to build two pergolas – on different sides of house. Constructed of cypress pine, anchored to ground in galvanised steel stirrups (concreted into ground) and attached to fascia board. The L-shaped units are 2.4-3.6m apart and connected by 3 strips of top hat. I need a registered building surveyor to check my initial design (on site) and then inspect after construction.

We're looking for a skilled handyman to help install several outdoor roller blinds around our pergola. The space is 7m x 5m, and we've already purchased the blinds and joiners. Details: - Pergola is approx. 7m wide x 5m deep - Blinds to be installed on outside of both 7m sides and 5m sides Blinds are a mix of sizes: 2 x 1.7m 1 x 1.5m 1x 1.8m 2 x 1.8m 2 x 3m We also have joiner pieces (10cm wide) to connect blinds so will need small spaces between them for connection (I think!) We'd love the handyman to bring the right tools for installation (drill, levels, ladder, etc.) Location: Ferntree Gully Preferred Date: Thur 15th May but can be flexible What we’ll provide: All blinds and joiners Access to the pergola and power What you’ll need: Experience with blind/awning installation Appropriate tools and ladder Precision to ensure neat and secure install Please let us know your experience with similar installs when applying

I need someone with pergola building experience to build a pergola. I will pay accordingly but putting a nominal price of $50 here

I've just brought a place with an open pergola. I am seeking ideas to cover it to have outdoor furniture. Keen to sought ideas and cost for the the same. Pergola size - 4100 x 3300 approximately

Pergola needed to replace the flooring/deck. A small job as the area is about 30sqf. Anotger job is to replace the garden door

Leaking Pergola polycarbonate roofing either fixed by cutting so water runs off into guttering, or replace the polycarbonate roofing with new materials

Already have a structure of pergola , need to build the shed and repair. Also, need decking repaired

I have a pergola made which is 25 ft/8 Meters in length and 9ft/3 meters in width. Currently it is not covered with any sheets so now I have to cover it with the transparent sheet to avoid rains on my deck. Thanks

I would like a quote for renovating my covered pergola. Currently it is constructed of bamboo. Any new cost effective ideas are welcome.

14 sheets 1 metre by 6-9ft to be installed

Please read my ad and refer to the attached picture before commenting or providing a quote Hello, This task is for someone to attend onsite and provide quotation to build the pergola. I'm looking for a Handy Man/Carpenter who has built a pergola before. The pergola is going on top of existing Concrete and will be attached to the wall. The artificial grass is layed on the Concrete which is 100mm No need for the roof. Please only bid if you are able to attend in person and provide quotation and are available within January or February to build the pergola