Find an experienced driveway repair contractor in Inner West Sydney

Automatic aluminium sliding remote control auto motorised gate for car entrance driveway approx 4metre wide opening . Suburb burwood.

Remove block paving then pour new concrete driveway . Approx 5metre by 4metre. Inside the house. Not the council land. Suburb burwood. Thanks. Alvin.

Move 2m3 of soil to backyard raised garden bed. Can supply one wheelbarrow and shovels. Woodchips to be removed from raised bed first.

Resurface concrete driveway with a finish

The edge of my driveway lips up as it meets the gravel and my car bottoms out. Needs to be flattened and smoothed so it is more flush with the gravel - Due date: Flexible

Need the paint removed off this parking at our business. It can only be removed by sand blasting will not come off with just a pressure wash

Remove both iron gates from driveway (including wooden supporting post)

Garage kerb steel plates were insufficiently fixed with small ~ 50mm concrete screws. Tried 10mm x 80mm expanding anchors, still came out. The car driving over the bottom part of the plates creates a lot of upwards force on the top part of the plates, due to a thick pipe in the gutter installed under the plate. I need a much stronger, deeper anchor installed, with chemical/expoxy/chemset, and using bolts or threaded rod at least 12mm and at least 225mm long. 10 anchors required total (whole top/ garage side, 2 plates each with 5 anchors). First you'll need to remove the existing anchors, and re-drill steel and concrete holes wider and deeper. If you have to remove the whole plates, then you may have to replace the 10 screws on the bottom side if they won't go back in nicely. You supply the anchors and all tools. I have power

prepare an area between a garden retaining wall and an existing driveway for concreting and fill with concrete, approx. 20sqm

Pick up 2 aluminium gates 1 metre height gates by 1600 wide 1 metre by 1 metre Drop to Kiama

You will need a drill, I think it is screwed into the wall

Lop off three branches from tree trunk & take away the tree branches.

Automatic aluminium sliding remote control auto motorised gate for car entrance driveway approx 3.5metre wide opening . i will arrange removal of existing old gate myself. Suburb burwood.

pour 40m2 concrete，no excavation needed

Breakup, removal and disposal of concrete slab driveway approx 12.5 sq m (4.1m long x 2.5-3.5m wide x 100mm thick). Top section mesh reinforced.

Automatic aluminium sliding remote control auto motorised gate for car entrance driveway approx 3.5metre wide opening . i will arrange removal of existing old gate myself. Suburb burwood.

I require approximately 1.5 m² of cobblestone which I will supply to be tiled in driveway and to be grouted tomorrow

Install cobblestone on my driveway. We will need 20-30mm screed plus seal. 31sqm. Cobblestone 20mm thick. Grout etc. driveway will be laid next week

Refresh the driveway gate, front door and possibly window sills (outdoor).

There is cracking on the driveway need to be fixed and resurface it. No idea need jet hammer concrete down and redo or just simply resurfacing can resolve it. Driveway is roughly 2m x 7m, only right side needs to be fixed.