Find an experienced retaining wall contractor in Stafford Heights

LOCATION: Stafford Heights, QLD I require an experienced bricklayer/block layer to build two reinforced retaining walls along both sides of my driveway. The existing retaining walls have already been removed. New concrete footings have been completed and starter reinforcement bars are already installed. Wall Dimensions: Wall 1 * Length: 5.3 metres * Height: 700mm at front tapering to 400mm at rear Wall 2 * Length: 5.7 metres * Height: 700mm at front tapering to 400mm at rear Requirements: * Supply and install 200mm concrete Besser blocks * Construct reinforced retaining walls using existing starter bars * Core fill reinforced cells with concrete * Install waterproof membrane to soil side of wall * Install French drain system behind wall * Supply and install 100mm slotted ag pipe * Supply and install drainage gravel and geotextile fabric * Backfill as required * Clean up site on completion Notes: * Concrete footings already completed * Starter bars already installed * Tiling/rendering not required * Wall will be finished by owner at a later date * Please provide fixed-price quote including labour and materials * Experience building retaining walls preferred What the contractor should supply * 200 mm Besser blocks * Mortar * Reinforcing steel (if additional required) * Concrete for core filling * Waterproof membrane * Geotextile fabric * 100 mm slotted ag pipe * Drainage gravel * Labour and equipment Questions to Ask Airtaskers 1. Are you a qualified bricklayer/block layer? 2. Have you built reinforced retaining walls before? 3. Can you provide photos of similar work? 4. Is drainage and waterproofing included? 5. Is rubbish removal included? 6. Is your quote fixed price including materials?

3m easy access 1 6m Long x 1m high Scope of work- Dig footing concrete footing Lay and fill blocks Backfill with drainage gravel and ag pipe I can supply all that is needed- 200 series blocks Vertical and horizontal Rio bar steel Trench mesh steel Concrete Cement Sand drainage gravel ag pipe

I need a site visit to quote on removal of a timber fence, repairs/improvement to part of a retaining wall, and installation of a new fence in a slightly different location to replace the previous one.

I’ve got 17 x galvanised UC sleeper posts that require cutting. There are ‘C’, ‘H’, and 90 degree posts. These are to be cut at the specified height and there are to be no burrs. I’ve attached some photos for reference. Method to be noted in submission.

Hi. I’d like someone to remove some concrete steps, an old retaining wall, and some dirt behind the wall. I have waste vouchers for this job.

Currently installing a retaining treated timber sleeper retaining wall. Will require cleaning, a light sand to remove sharp edges, splinters etc. and applying a decking oil or similar for the finish. Square metres to be finalised, approx. 100m2. The photo is just a sample.

Repair Retaining Wall Details mentioned in the attached photo

Finding it difficult to know the person I’ll need here. Retaining wall leaning forward. We had resin under the house and retaining wall to stop any sinking. We now need the retaining wall pushed back. It’s not leaning too much, there is a sizeable crack. We will be selling the house next year so want it to be fixed. Measure about 12m and slopes from a few inches high to about 1.5m. Any approx quotes appreciated.

Hi. I need 8 post holes for a retaining wall. The holes will need to be 1m deep. An Auger will be needed as the ground is clay. There are no utility lines or pipes nearby (I have the plans). Access to the site is restricted to a maximum of 1m width.

Need retaining wall to be supported. It was injected in February with resin to stop any further sinking but now needs anchoring in for full support and to straighten out the wall. After quotes, thanks!

Hi. I'm after someone to build a retaining wall at my house. The wall will need to be (builders) block and rendered. I don't have any builder's blocks. Thanks Rob - Due date: Flexible