Find local power point installers in South West Sydney

Install 3 new single power points on existing walls. I can get the power points from bunnings.

1) Install 15A Single Power Point (Qty1) 2) Make a complete cable with 16A plug (Qty3)

Install a Power Point from an existing power switch. The power cable sould run consealed through zipbroke.

Need a power point installed under my stairs

• Install 4 outdoor weatherproof power points. Each location is either back-to-back with, or very close to, an existing internal power point. Weatherproof power points will be supplied. • Install 4 new LED wall lights to the front of the house. This includes two lights mounted on the house wall and two mounted on brick piers. Access to wiring will be via the ceiling/roof space. The LED wall lights and 1 x two-gang switch will be supplied. • Replace 2 existing internal ceiling light fittings with new LED ceiling lights. Lights will be supplied. • Install 1 additional external wall light adjacent to an existing light of the same type. The light fitting will be supplied. The parts listed above will be supplied by the owner as stated. The electrician is to provide all other materials required to complete the installation, including cabling, fixings, connectors, consumables, and all necessary tools and equipment.

I need to request the disconnection and decommissioning of this setup. The power source is likely connected to an existing indoor electrical outlet, which was originally installed by the previous tenant. Also remove the data cable. Photo is from the back of the house under carport.

Install power points and data points. Cabling already there. Assiting electricians currently on site

Fix a kitchen power point. Location is the paper mill in Liverpool

we just wanted to add a power point for the TV wall hang-up and another on the other wall.

Hi, I'm looking for a licensed and insured electrician to complete a small fit-out in my apartment in Liverpool 2170. Work required: • Install 1 or 2 new double power points (GPOs) – exact number and wall locations to be confirmed on site • Install 2 x pendant lights (light fittings supplied by me). You will need to bring the switches • Install 1 x downlight (fitting supplied by me) What I need included in your quote: - Work carried out to AS/NZS 3000 standards - Testing and a Certificate of Compliance (CoC) on completion I have attached photos of the of the ceiling and the wall where the installation will happen

One power point broke need new one and 3 ligth globe fixed

Need Licensed Electrician to supply and install double power points in laundry and opposing side of wall.

Relocation an outdoor power point to another wall nearby

I need 1 Power point installed in my garage. It is 1.5m away from another PowerPoint. I’ve purchased the new switch already. It is a single story house. Need it done today or tomorrow

Please provide the quote I need a licensed electrician for the following: 1. Replace a burnt/damaged 10A wall socket (GPO) • See attached photo • Check wiring behind wall for any damage 2. Install a new dedicated 15A outlet for EV charging • Run directly from switchboard (located on the other side of the wall) • Include RCBO / safety protection • Suitable for continuous EV charging load Notes: • No adapters will be used — proper EV setup required • Easy access, short cable run (same wall as switchboard) • Please include materials + compliance certificate

Hi, I need a power point installed on a concrete wall inside my lounge room, there is already an exisiting power point there on the same wall, I only need another one a meter or two along the wall

Install 2 power points. I will provide PowerPoints. Also replace existing front sensor light. Again I will provide the light. All work in same area near front door

Need a PowerPoint stored for a wall for TV, can go up into manhole and drop down wall for a new power point for TV

I need my internet modern moved from upstairs to down stairs

I need to install the on like on the photo on the wall where it’s been marked with orange do. Mirror will be sitting on top so the power point need to sit inside the gyprock just like the down light. If you can do the job please let me know.