Find professional metal gate repairs in Inner West Sydney

I have automatic metal gates. One gate is grating on the ground at the end of its swing. It needs an angle grinder to shave off about 7.5cm of the gate by a couple of millimetres.

I need a metal gate to be installed on the existing post. I have purchased the gate and strap and hinge set. I can pay for timber screws and installation cost.

damage caused by rust。。i need someone to help for rewelded total 9

Hi , I have metal gates (already purchased) that I need installed. I'd also like to have matching poles installed between the brick columns of my house (pictured). I've attached a picture of similar poles that I like, but need them to be powder coated in 'Surfmist' to match the gates. I'll need two poles between each brick column, for a total of eight." - install gates - purchase , powder coat & install poles Thank you

Metal gate has broken in a couple of places and needs welding. One hinge also needs reattaching.

Require experienced trades person to install a metal / colorbond swing gate. Can be a double or single gate. Driveway is 2850mm wide. Gate(s) to be attached to metal pole (s). You will need to source metal / colorbond gate(s) and poles to attach gate(s). Photo proposed gate(s) installation. - Due date: Flexible

I need someone to find and implement a permanent solution to stop a metal gate banging against a brick wall upon opening and against its own latch upon closing. Any takers? - Due date: Flexible

My front door gate hinge is broken (rusted off). It is a heavy metal gate. The hinge needs to be replaced. - Due date: Before Friday, 1 September 2023

The concrete holding our gate up has broken and the gate now doesn’t swing properly. Would need someone to reinsert the gate post so it functions as intended. Would also need some mesh installed to pet proof the gaps. - Due date: Flexible

A hinge on my rear fence has snapped. I need someone to replace and weld a new hinge to repair the gate. - Due date: Needs to be done on Saturday, 22 April 2023

Gate is bent and cannot close one of the bottom panels put back on plus needs hinges put on the bottom panels to stay up when open.

I have 2x metal gates at the front of the house, they are 85cm wide and less than a meter high. The mesh is missing from the gates. I need new mesh fitted. I have the mesh already. You would need to cut the mesh to the correct size and then fix it to the gates. The mesh is thicker than chicken wire - it's like this: https://www.bunnings.com.au/emu-wire-950mm-heritage-woven-mesh-primrose_p0024303 - Due date: Flexible - Due date: Flexible

I need 2 x small gates 875mm x 815mm with metal 17mm thick to be removed from its hinges by taking off the C bracket and sliding off- gates in tact. The c bracket and screws attached to the brick wall have been previously covered over with render. May need an angle grinder? Would like to leave as little damage to the wall as possible. Please let me know your thoughts. Either today (10/8/22), Friday (12/8/22) or Saturday (13/8/22) - - Due date: Needs to be done on Wednesday, 10 August 2022

You’ll need to measure, purchase and install the gates. Attached are the two existing gates, and an example of the types of gates that we would like to replace with.

Grind off rusted hinges and replace

The lock on gate is broken

Metal pole is 1m in height needs to be removed and hole patched. The driveway gate has been removed but the pole still standing.