Find trusted mechanics in WA

Inspection if possible to see if there is any problems and if all good a regas. Car is blowing warm air

Install into a Jeep Wrangler 2013, We have the head unit and facia kit Reverse camera needs t be connected too Ideally at our home but can take jeep to you and wait for install

Replace drivers side wheel trim and patch up rear bumper paint

Golf 7 TSI 2013. Air-conditioner regas

I’m looking to get a car service quote My car is Hyundai Getz 2011 5 door manual 1.4L I need: - General basic service - Either the front or back brakes replaced as they are squeaky/squealing now (not sure if front or back) - Not sure if just brake pads or more need replacing - My last service at RAC said the rear pads are around ~2mm so assuming the back ones Looking to know - What availability you have including on weekends - Can the service + brakes be done in the same day - Cost for service - Cost for front brakes - Cost for back brakes Thanks You would need to supply tools and parts. Happy for you to inspect first to see what needs doing Budget flexible

Jack up my small sedan Holden Cruze sedan car Needs Allen key to remove plug of tank Drain engine oil completely and take away Refill new engine oil - I have new oil At my house

Looking for someone experienced to replace the clutch and concentric slave cylinder on my 2007 Ford Focus, 2.0L petrol, 5-speed manual. The slave cylinder has failed. As the gearbox and clutch need to come out to replace it, I’m fitting a new clutch rather than reinstalling the worn one. Parts and fluids supplied; labour only. Overseas-qualified mechanics and later-stage apprentices are welcome. You should have experience with front-wheel-drive clutch replacements and be confident completing the job independently. I’d be happy to support someone building their career or getting established locally. Please describe your relevant experience and similar jobs completed. The car is non-driveable, so work will be in my driveway outside my home workshop in Success. Tools available: • Transmission jack, 2.5t and 1.5t trolley jacks, four axle stands and wheel ramps. • Torque wrench, metric sockets/spanners, deep sockets, extensions and breaker bar. • Torx/E-Torx sockets, pry bars, compressor, air ratchet and impact wrench. • 3D-printed clutch alignment tool for this application. • Vacuum brake/clutch bleeder. I can hire engine support equipment and purchase other specialist tools by prior arrangement. Please flag anything needed beforehand. Budget: $350 for labour, open to reasonable offers. Your offer should cover clutch and slave cylinder replacement, reassembly, bleeding and checking operation on completion.

The car Is a Nissan Pathfinder 3.0 diesel, i ran out of fuel and After adding It again its not starting. Probably some air in the fuel filter but this car doesnt have a manual primer so i Need an esternal pump to fix the air bleeds. The car Is located in broome Road close tò the caravan park

Flush old oil and refill new one

Needing a qualified mechanic to look over a second hand car I’d like to purchase. Needing to make sure everything on the car checks out, and there are no mechanical issues. Qualification/certificate required to be presented to us as proof you are a mechanic

Both front low beams died at the same time, assuming it was likely a light fuse that needs changing. Mitsubishi outlander 2018. I'm in Darlington but happy to travel to get it done.

Alfa Brera 1750 tbi making noise from engine bay when running. Need car diagnosed and fixed if possible (will do any repairs in seperate job, this is just for doagnosis).

Need an experienced mechanic to inspect a car before i buy it.

Qualified mechanic required for busy workshop. Experience in car servicing, brakes, suspension and every day to day repairs. No tools required. Immediate start & opportunity to be casual after task is finished. If you can't do the basic repairs & you are not qualified, do not reply. Task is for Thursday 9th July for 7hrs. FiFo mechanics can apply. Must have current driving license.

Looking to buy a 2003 Honda CR-V from marketplace, and hoping to have someone check it out before we buy. Seller is in Shelley, looking for someone to meet me there around 5:30-5:45pm tomorrow. Price negotiable

I have brake pads and brake fluid. Needs pads replaced and brakes bled so they stop screeching when I drive.

Need someone to help me change the engine oil & filter for my MG 5 1.5L CVT. I will provide the oil and filter. I have a hydraulic jack if needed.

oil cooler exchange and bushings Land rover Sport 2007

Looking for someone experienced to install a new CarPlay head unit into my 2014 Jeep Patriot. I have already purchased and will supply all components, including: • Head unit (Android touchscreen) • Fascia/dash kit • Wiring harness & RCA cables • Trim removal tools Scope of work: • Remove existing head unit • Install and wire new unit correctly • Ensure clean and professional fitment into dash • Connect and test all functions Key requirements: • Steering wheel controls working (if compatible) • Reverse camera connected and working (if applicable) • No loose wiring / no damage to dash • Everything tested before completion

I have a new clock spring for my Nissan Dualis 2012 which has been installed but just needs the wires to be connected properly as soon as possible please.