Find a kitchen installation professional in VIC

Small L shaped IKEA installation. Approx dimensions - 2.4m x 3.7m. See picture for reference.

full kitchen and bench top installation

Looking for a licensed plumber and electrician (or a team capable of both trades) to carry out works associated with a new kitchen installation in Mordialloc. The kitchen layout will remain largely unchanged, with the sink, oven, cooktop and dishwasher staying substantially in their current locations. Electrical works: - Disconnect existing appliances during demolition. - Supply and install a dedicated circuit from the switchboard for a new induction cooktop. - Wire and connect the induction cooktop. - Reconnect existing electric oven. - Relocate or install any required power points. - Test and provide compliance certificates. Plumbing / Gas works: - Disconnect and permanently cap the existing gas line to the cooktop. - Install and connect the new sink and mixer tap. - Reconnect dishwasher. - Carry out any minor plumbing adjustments required to suit the new cabinetry. - Test and certify works where required. The work will need to be completed in stages and coordinated with the kitchen installers: - Initial disconnects during demolition. - Rough-in after old kitchen removal. - Final fit-off after cabinets and benchtops are installed. Kitchen installation dates are currently TBA, so some flexibility will be required. Please quote only if suitably licensed and insured. Experience working alongside kitchen installers is preferred. Location: Mordialloc, VIC.

We had someone install our Ikea kitchen. They did it free of charge so I'm im great full but just a few things need fixing up. Small defects. I'd like someone with experience to come in and tidy it all up. It's things like cabinet door alignment, Fixing door installation to ensure its flush. Possibly an end panel or two put in. Things like that. Also happy to discuss any improvements you think may be needed in person. No materials will be needed from you. Happy to do it on hourly rate

Need installation. Happy

We have to make butler pantry , shelves needs to come off and make a butler pantry

In-scope: - Removal of 1 base cabinet - Removal of existing tap and sink (to be replaced in new kitchen) - Removal of stove top (to be re-used in new kitchen) - Removal of all bench tops - Removal of existing cover panels & filler pieces - Installation/ cutting of new cover panels & filler pieces - Installation of 1 high cabinet - Installation of door knobs - Place dishwasher in correct position - Ensure all case cabinetry is level and ready for stone bench top installation Out of scope: - Installation of door and drawer fronts - Installation of bench tops - Plumbing associated with connection of dishwasher - Painting etc. Can provide additional photos on request.

Install ikea kitchen flatpack

Remove and install Ikea kitchen cabinets. This is a small galley kitchen approx 3m x 3m. Very basic kitchen.

I need someone to install the kickers, adjust the doors and few little things around the house, such as install trimmers to the floor. Range hood needs to be installed. Some skirting around the small toilet downstairs, This is a renovation project, final bits to do before hand over. All materials are on site. Please send hourly rate

IKEA kitchen installation Cabinets already assembled No plumbing or electrical required Just mounting and benchtop Budget $500-600

I have an IKEA METOD kitchen where all cabinets are already assembled and positioned. The remaining work is mainly installation, alignment, and finishing. I initially planned to complete it myself but realised I don’t have the required tools for proper panel cutting, levelling, and clamping, so I’m looking for a reliable installer to complete the job efficiently. Scope of work: • Mount and secure cabinets to wall • Ensure full levelling and alignment (important for upcoming stone benchtop) • Cut and install panels, fillers, and end pieces where required • Build and install bulkhead • General finishing to a clean standard The layout has already been simplified (some cabinets removed from original plan), so the scope is more straightforward than a full install. Laundry (small additional job): • 130 cm space • 1 × 60 cm METOD sink cabinet (assembled) • Install laminate benchtop and sink • To be completed after tiling (can be scheduled separately if needed) Notes: • Property under renovation, easy access • I will be onsite and can assist if needed to keep things moving • Kitchen is ready to go now • Looking for someone who has done IKEA kitchens before and knows the system well I’m after someone practical, efficient, and reasonably priced for this type of work. Location-Belmont – happy for inspection prior to quoting Please include: • Brief experience (especially IKEA installs) • Availability • Quote (or estimate range)

Need someone to remove old.kitchen and install kaboodle kitchen

Looking for an experienced 4WD installer to fit a drawer and kitchen system into my 2015 Volkswagen Amarok. This is NOT a bolt-in job – the install will require drilling and proper alignment, so experience with similar setups is important. Scope of Work: Install Kings 1300mm drawers Install Kings 1300mm pull-out kitchen Install wing kit to suit Drill and bolt system securely through tub floor (no movement/rattles) Ensure correct positioning so drawers run straight and tailgate clears Work around tub liner (cutting or drilling through as required) Key Requirements: Experience installing 4WD drawer systems (Kings or similar) Must understand how to: Align drawers correctly in a non-square tub Drill safely (check under tub before drilling) Avoid fuel lines / brake lines Clean, solid install – no rattles or loose mounting Take care not to damage tub or interior trims Location: Keilor Park VIC Timing: Flexible but prefer ASAP I Will Supply: Kings 1300mm drawers Kings 1300mm kitchen Wing kit You Bring: Tools Drill bits / rivnuts / mounting hardware if required (happy to reimburse) Additional Notes: Amarok tub is not perfectly square, so proper setup and alignment is important Preference given to installers who have done this type of job before 👉 Please include photos of previous drawer installs with your offer

Looking for an experienced cabinet installer to install a custom pre-assembled kitchen in a ground floor apartment. Scope of works: Install medium L-shaped kitchen cabinets (all cabinets pre-assembled) Install small floating vanity Install a couple of small wall cabinets Ensure cabinets are level, fixed securely to walls and aligned ready for stone benchtops. Also requires 3mm template cut ready for stonemason Details: Location: Melbourne Access: Ground floor apartment (easy access) Cabinets will be on site and ready to install. Requirements: Proven experience installing kitchens/cabinetry only Must have own professional tools (laser level, cabinet clamps etc.) Attention to detail and quality finish Please include photos of previous kitchen installs Only experienced cabinet installers will be considered.

Complete kitchen installation. Carcasses done and squared and need bench installed, kick boards on, doors on and sideboards installed. Plumbing completed if possible.

I have an IKEA METOD kitchen where all cabinets are already assembled and positioned. The remaining work is installation, alignment, and finishing. Scope of work Mount and secure cabinets to wall Ensure precise levelling and alignment, especially for upcoming stone benchtop Cut and install panels, fillers, and end pieces as required Build and install bulkhead General finishing to a clean standard The layout has already been simplified, with some cabinets removed from the original plan, so the job is more straightforward than a full installation. Laundry as a small additional job 130 cm space 1 x 60 cm METOD sink cabinet, already assembled Install laminate benchtop and sink This can be scheduled after tiling if preferred Notes Property is under renovation with easy access I will be onsite and can assist if needed Kitchen is ready to start immediately Prefer someone with solid IKEA kitchen experience who understands the system well Location Belmont, happy to arrange an inspection before quoting Please include Brief experience, especially with IKEA kitchens Availability Quote or estimate range Looking for someone practical, efficient, and reasonably priced for this scope of work.

To assist builder in kitchen and help paint walls. Experienced standard please.

I require a cabinet maker or kitchen installer to assist with the following: - CNC Cut and two-pack paint 10x 18mm MDF kitchen cabinet panels to match existing shaker cabinet profile and colour. - Shift a two meter run of cabinets and install all the cabinet panels, including on integrated fridge and integrated dishwasher. - Cut down or re-construct an 800x800x400 melamine carcass to fit new integrated fridge cavity. Happy to discuss more detail and share images and detailed cabinetry drawings.

Looking for someone with Kitchen skills who can help me upgrade our current kitchen - photo attached. Something similar to - photo attached. Assist me in pulling the old one out, over viewing my choice in 2nd hand Kitchen assembly and installing the new kitchen. The gas stove and the dishwasher and sink will need to be moved to allow for a large double fridge. And the sink moved under the window. Hourly / daily rate preferred (abn only -no gst preferred) until the job is done.