Find a local Tasker to inspect your Jeep in WA

Replace driver door lock actuator on Jeep Wrangler 2018. Door lock actuator has stopped working. Looking for someone experienced with Jeep/door trim removal. Please quote labour only. Must test central locking after install. We have the part ready to be installed.

Tail light wiring is faulty. Initially thought the bulb was blow. I removed the bulb and inspected and it was fine. I installed the suspected faulty bulb in the other tail light to confirm it was fine and it is all good. The wiring for the left tail light appears to have been tampered with before and looks very shit and not the same as the other side

The trailer output is getting some currwnt through, but doesnt seem tk be enough to getthelights to work on a trailer. (Trailer lights work for other cars). Can someone please take a look and help fix so I can tow a trailer?

Quote mechanical repairs

Car service and check over

Looking for someone experienced to install a new CarPlay head unit into my 2014 Jeep Patriot. I have already purchased and will supply all components, including: • Head unit (Android touchscreen) • Fascia/dash kit • Wiring harness & RCA cables • Trim removal tools Scope of work: • Remove existing head unit • Install and wire new unit correctly • Ensure clean and professional fitment into dash • Connect and test all functions Key requirements: • Steering wheel controls working (if compatible) • Reverse camera connected and working (if applicable) • No loose wiring / no damage to dash • Everything tested before completion

Hi I need some repairs done on my Jeep.. because it’s a Jeep thing Replace tie rod ends (I have parts) Replace radiator (gotta pick up 2nd hand) Linkage arm for transfer case needs grommet

Not keen to touch Jeep electrics, antenna install to bullbar. Wired to ignition so needs key on to use

Trying my luck. I have recently got my diagnosis back for my 2009 Jeep Cherokee Limited, there is abit of work that does need to be done and looking into cheaper options to get it repaired. 1 x rear main seal 1 x front main seal 1 x oil pan gasket 1 x water pump with gasket 2 x Valve Cover gasket kit 1 x thermostat with gasket & timing chain cover seal

Looking for someone experienced with welding/fabrication to help build a custom DIY roof rack for my Jeep Wrangler JK (soft top). I want a clean, practical design and I’m open to ideas. Ideally looking for someone who can help with design, fabrication, and installation. happy to discuss cost depending on experience and setup. Located in Perth. Flexible with timing.

Yakima roof racks already put together just need to secure them to roof rails on the jeep.

Need a oil filter and oil changed

My car aircon needs to be regassed

Fuel pump died in my 97 wrangler I have a new fuel pump I need someone to remove fuel tank and replace fuel pump then replace fuel tank. I need this done today

Installing flow series under body light strips for my Grand Cherokee jeep, lights are measured for the specific car model, flow series module to be installed, light strips to be secured properly under the car.

install the new head unit for Jeep Grand Cherokee https://www.cjindustriesaustralia.com/collections/jeep-head-unit-packages-with-wireless-apple-carplay-android-auto/products/jeep-grand-cherokee-2014-2022-plug-play-head-unit-upgrade-kit-car-radio-with-wireless-wired-apple-carplay-android-auto?variant=44370041110678

Need a mechanic to swap an oil cooler assembly on a Jeep Grand Cherokee 2016 diesel and refill engine oil (engine oil supplied). Note: It is side-mounted so is easier to access.

asd/main sense circuit issues. I have fixed alot of showing wires, i droppes the fuel tank the pump is good. The auto shut down (asd) is not sending signal or ground from the pcm to the fuel system to allow jeep to run. It has gone past my knowledge now and i need somome to come and look at it.

No spark in 1998 jeep XJ. died whilst driving and has not turned on. Cranks but does not turn on. 5 volts at cmp and cpk sensor Tested for shorts none present Tested for ground. Ground present New spark plugs, Leads, rotor 6 months ago new plugs and coil also New pcm 1999 six months ago. asd relay seems operational Signal wire from pcm to ignition coil ok Cannot get car to provide signal to spark from pcm to ignition coil when cranking Cps sensor replaced with cheap one. Old one in glove box. If you can get the car to start you’ll need to put a 10a fuse in fan relay. Labelled near fuse box in engine bay (driver side engine wall) If anyone can confidently diagnose/fix this issue please let me know!!

I need help with taking the engine out of my car. Someone with experience. It is a Jeep Grand Cherokee 3L Diesel. I need to take the engine out and repair the engine.