Find a local electronics repairer in Eastwood NSW

1.1 Wall and ceiling touch-ups Carry out localised paint touch-ups to internal walls and ceilings where defects, marks or paint drops according to the painting work list. Lightly sand defective areas, spot prime if required and apply touch-up coats to achieve a uniform finish with surrounding surfaces. 1.2 Cracks, gaps and corner defects Use flexible paintable gap sealant at cracks and junctions, then repaint/touch up to match surrounding surfaces at approximately the following locations: - Wall/ceiling or corner cracks (approx. 20 places) - Door corners (approx. 22 places) - Curtain box / pelmet ends (gaps approx. 4 locations, gap between box and 2 *5m) - Ends of window pelmets (approx. 5 places) - Bevelled skirting (approx. 5 places) - Shadow line skirting(approx. 8 places) Finish to a smooth, neat line with no visible gaps after painting. 1. 1.3 Nail hole touch-ups Fill and touch up nail holes (approx. 10) to Gyproc wall. Sand smooth touch up paint to blend with existing. 3.1 Existing Colorbond fence repaint Fence lengths approximately(only one side): - 4 m × 1 m - 48.73 m × 1.8 m - 4 m × 1 m - 37.63 m × 1.8 m (approximate total as per site measure).

Awning collapsed in a storm. Electricity has been isolated. Needs to be dismantled and stacked on site.

Taps in bathroom sink, bath tub and shower to be replaced . taps will be supplied.

27-35 Doomben Avenue, Eastwood, 2122 Hi, I have a problem with my toilet. After flushing, the water keeps running and won’t stop. I’m not able to open the toilet tank lid myself—it seems to require special tools. Could you please help me fix this issue? Thank you!

Hi there, I am looking for an experienced Handyman to help me build two pieces of furniture I just bought online. 1. 2 Drawer Bedside Table 2. 4 Door cupboard (Assembly requirements says it requires two adults and 1.5 hours) Can you please let me know your previous experience in building flat pack furniture and also please bring your own tools, Many thanks,

Replace the existing hot and cold shower head taps in bathroom and install the new taps that have been purchased. Attached the photo of the existing taps in shower and the replacement one

Two small paint chips need a quick sand and coat. Paint not provided

Need to tile over the outdoor cement floor, area is 2.1m*3.2m. And there is also a little step near the door needs titling. I have tiles and the job will involve some cutting. Need to bring your own tools and other materials. The length of steps need to match the porch, 3.2m. It is better if both jobs can be done together. We do have bricks, and need to bring your own tools and other material. However it is ok if you cannot do bricks steps, we will post another task.

Epson Ecotank ET2810, won't turn off, (only can do this by taking power plug off), lights blinking etc

Hello! Need help to relocate taps for basin and laundry Images for current and laundry room plan Thank you

A plumber has been unable to clear a blockage using a water jet and electric eel. They believe a pipe has collapsed in which case we would need to replace a new boundary trap up to the main board.

1. Waterproof wall, re-install tiles and grouting about 3-5 tiles on shower wall following a wall pipe repair. 2. Re-install tap covers on shower taps that were removed due to pipe repair. - Due date: Flexible

Two steps needed to be done in front of the house. Full width 3.2m needed to be done. I have bricks. Please bring your own tools and other materials needed. - Due date: Flexible

Replace taps in shower (new fittings ready for installation). Replace mixer tap in kitchen (new tap ready for installation) - Due date: Flexible

One of the circuit breaker at my house keep tripping everytime turn it on, it trips about half minute after turn it on. The circuit is responsible for several switches on the wall, I have disconnected most of those but still seeing the issue. I need someone to debug and fix asap - Due date: Needs to be done on Monday, 27 March 2023

I have stiff hard to turn kitchen sink taps, one tap now keep dripping and have to turn it off harder to eliminate the issue. I understand the washer or similar needs to be changed or adjusted. They are older style turn taps that you turn in a wrist motion. I require at least one tap to be adjusted so it stops dripping. - Due date: Needs to be done on Friday, 31 March 2023

Please help me to connect this drain hose to the sewer and water hose to taps. The washer brand is Samsung WA13M8700GV/SA. PLEASE MAKE SURE you know how to this and bring the necessary parts. I WON'T PAY IF YOU FAIL TO CONNECT DRAIN HOSE AND WATER HOSE. The drain hose's diameter is ~ 30mm and the drain pipe's diameter under sink is ~15mm. The drain hose may not be standard so please make sure you have experience with this. And the water hose is little bit short to connect to taps. - Due date: Before Thursday, 29 December 2022

2 taps are leaking - 1 only slightly the other more so See photos - Due date: Flexible