Find a local Tasker to replace your engine in VIC

i had battery replaced in the drivers side floor of 2011 fiat scudo van, then the engine wouldnt turn over, i called my brake down road assist. they ran tests and also a wire from battery + to other side of mobiliser, it did turn the engine over. this was late at night then told me to get auto electrician

Hi, I need a mobile mechanic in Fitzroy to replace the engine mounts and the starter motor on a 2006 Honda Civic 1.8L Automatic.The top right-hand side (RHS) hydraulic mount has completely collapsed and the lower rear torque mount is snapped, which has caused the engine block to drop down significantly out of alignment.I have all the parts physically here with me today:A brand new 4-piece engine mount kitA brand new OEX Starter Motor (DXS599) ready to goImportant Notes for the Job:You must bring a trolley jack and wood blocks to carefully raise the sagging engine block back up into its correct structural alignment before removing the old mounts and bolting on the new ones.Because the engine block has dropped, access to the starter motor area is tight. The mounts and the starter will need to be swapped during the same session while you have the block supported.

My car had a cold error and engine error sign came up after a long trip and stopped stating, I had recently changed the injector in the Audi Q7 and all errors are gone, but car still wont start. Fuel injector has been coded. I just check the engine oil today and found it gone up a lot. Looks like fuel is getting mixed.

need help diagnosing a misfire/rough running on my bf falcon xr6

My car has been overfilled with engine oil and I don't want to drive it until the level is correct. Looking for a mobile mechanic to come to me and bring it back to the proper level. Vehicle is 2005 Mazda 3 sedan.

Looking for someone experienced with 12V automotive electrical work to run power from my battery/battery box located in the canopy through to the engine bay of my Ford Ranger. The main job is to run a properly protected cable from the canopy battery to the engine bay so I can power a 12V fridge. I’m looking for a neat, professional installation with the wiring securely mounted and protected from heat, moving parts and potential damage.

Looking for someone experienced with 12V automotive electrical work to run power from my battery/battery box located in the canopy through to the engine bay of my Ford Ranger. The main job is to run a properly protected cable from the canopy battery to the engine bay so I can power a 12V fridge. I’m looking for a neat, professional installation with the wiring securely mounted and protected from heat, moving parts and potential damage.

Changing Mazda 3 engine oil and oil filter

Auto elec required to complete electrical tuck in engine bay.

Looking for an experienced mechanic to replace 3 engine mounts on my 2015 Toyota Aurion GSV50R, 3.5L V6 (2GR-FE), 03/15 build. All replacement mounts have been purchased and are ready to install (new Transgold mounts). Mounts to be replaced: - Left-hand engine mount - Right-hand engine mount - Front engine mount Ideally looking for someone experienced with engine mount replacement and who has the appropriate tools/equipment to safely support the engine. Keen to get this done ASAP. Happy to travel locally if required (South East Melbourne area).

Engine has dropped a valve.

2x engine mounts replacement 2 of the holes have messed up thread so may need to be tapped, old bolts are also messed up

On Subaru Outback 2013 To clean the DPF Plus Camshaft position censor

My ford fiesta 2010 diesel , suddenly started having a rough sound from the engine, it still runs but sounds like a tractor, someone please help me to diagnose what’s wrong with it

Looking for my car's engine hood and roof respray.

Need serpentine belt looped around pulleys. Have belt just need someone who knows what there doing with tensioner. Quick job if know what doing. Hit me up either way your offer. Need done asap.

GWM Cannon 21'- engine has supposedly failed. Require a licenced mechanic to remove existing and install new. We will supply the new engine. Can we please include a service also. Thank you

My VW shows this warning light, it doesn’t always appear. Please help me to fix problem

Open to quotes and flexible with time thanks

While topping up engine oil , I added more oil than required. As shown in picture. So it's well above the maximum mark. Although I don't see any immediate problem, I would like to remove excess oil and just keep to the mark. I don't require change of Engine oil or any other services...just extract excess oil. Vehicle:- Honda Accord 2006 model ivtec.