Find skilled builders in Maroubra Junction

Considering installing this shed inside an existing narrow carport space and looking for advice on feasibility plus installation quote: * MIGHTYMO 1.8m x 4.2m skillion roof shed. * https://shedsandcarportsonline.com.au/product/garden-shed-1-8wx4-2dx2-0hm-skillion-roof/ Space dimensions: Width between posts: 2.35m Rear height clearance: 2.07m (increases throughout carport) Depth under roof: approx 5.07m Flat concrete slab No obstructions Main concern is whether assembly is practical within the confined space and whether there are any clearance concerns. Would appreciate: * feasibility assessment * approximate installation cost * any concerns with this setup Can provide photos if needed.

Looking for an experienced concreter to extend an existing driveway beside my house. Scope of Works * Prepare and pour concrete driveway extension beside existing driveway * Area is approximately: * 525cm long * 80cm wide * Extension runs: * From the front edge of the sliding gate rail * Under the sliding gate rail * Through to the existing pathway near the front door * New concrete to tie neatly into existing driveway and pathway levels * Smooth finish required to match the existing driveway as closely as possible * Ensure suitable base preparation and reinforcement for vehicle use * Remove spoil and clean up site after completion Owner Responsibilities * Owner will remove: * Existing concrete pavers/tiles * Timber stepping stones Notes * Please see attached photos for layout and area marked in red * Access is straightforward * Looking for an experienced concreter with attention to detail and clean finish work * Please include: * Whether you are licensed and insured * Estimated timeframe * What is included in your quote

Looking for an experienced installer to help set up a sliding gate at the front of my driveway in Maroubra. Currently no gate installed. Opening is approx. 3 m. Driveway has concrete slab with brick post on each side. To slide onto the hedge side. Scope of work: * Install posts (or use existing if suitable) * Install and align sliding gate track * Mount sliding gate (gate can be purchase based on your advice) * Ensure gate runs smoothly and is level * Install automatic gate opener (solar or battery kit) (please quote separately) * Advice on best budget setup Notes: * Access is straightforward * Prefer someone with previous sliding gate experience * Please include photos of similar jobs if possible Budget: Open to quotes (looking for a cost-effective solution) Location: Maroubra NSW When: Looking to be installed around 1 May. Note: Happy to assist on the day to reduce labour time/cost.

Removal of old render from building walls. All tools will be provided.

I need an electric gate motor installed for an existing driveway gate. Power supply is already at the gate. Only need a motor installed and connected. Gate is approx 4m long.

About a meter 75 mm roof panels insulated pergola extension. About 90 cm width & long about 500 cm.I already got Pergola. Have to be same colour to match.primrose colour & white inside roof to match. As you see at photo.Also need to put net on gutter.

I have an existing pergola per photos. Structurally very sound I want to replace the existing aluminium post with merbau timber posts. New posts are to fit into steel base plate and anchored into existing concrete. Budget is for labour only. Material costs would be additional. Licenced builder required.

Hi there, Group of 3 townhouses in need of their driveway pressure washed, sealed and painted if that's a thing. Dimensions: about 5m by 20m it is quite big and probably require quote on site visit. Dirveway is dirty and will need some light repairs ( small cracks) to be done too. It was painted beige-ish with green pattern that we would like to keep. Located in 2035 Maroubra, we are looking for quotes to submit to our Strata committee for approval.

Overgrown olive tree is overhanging pergola and dropping leaves, branches and olives non stop. Tree needs cut back significantly and pergola roof needs cleaned of tree debris.

Rebuild Ikea PAX Wardrobe - View all the details of this offer: https://www.airtasker.com/offers/01HMJ5QZ2NEJS13HT5ZNGFAK47

I bought an Absco garden shed (3.0 m x 3.0 m x 2.06 m) from Bunnings. I have made the walls, part of the door and part of the roof. I need a hand to finish making the door and roof, to assemble the shed and secure it to a concrete slab, which is already in place. - Due date: Before Sunday, 14 January 2024

Dismantle wooden pergola approx 3 m high and 2.3 m width and depth. Remove and disposal of all pergola materials from property. - Due date: Before Sunday, 17 December 2023

I have a gaming pc that I am upgrading. I need help taking it apart then rebuilding with new parts. - Due date: Before Sunday, 14 May 2023

Metal pergola from Vida XL Amazon. Needs assembling. Was able to put together some parts but I’m puzzled about the rest. Ni special equipment needed. It’s just screws. Thanks - Due date: Needs to be done on Friday, 13 January 2023

2 of our Sunlite panels have come off our pergola after the last big wind in Sydney. We have all the panels, rubber surounds and metal fixtures. The metal fixtures need securing to the wooden pergola. The other panels are secured but these last 2 are not. So it would seem sensible to secure the 2 loose panels in the same manner as the others, as they withstood the wind. - Due date: Before Friday, 16 December 2022

Floor Planks Tiles Self Adhesive Wood Effect Need cleaning. Need to come out to quote - Due date: Before Friday, 6 January 2023

We’re looking for someone with experience assembling sheds. Plenty of space to build. Must have own tool. Please see QR code for reference - Due date: Needs to be done on Friday, 2 December 2022

Small empty bedroom with old carpet.I want laminate floorboards 3.6 mts x2 - Due date: Flexible