Description: Hi! I need someone to remove my old kitchen mono mixer tap and install a new one that I’ve already bought: Enza Tamara Single Lever Antique Brass Monobloc Kitchen Mixer (comes with flexible tap tails). Details: ∙ Single-hole composite inset sink, the existing tap is also a single lever mono mixer, so it should be a straightforward like-for-like swap ∙ The current tap is connected with braided flexible hoses to compression fittings under the sink (photos attached) ∙ I’m not sure if there are isolation valves. If there aren’t, please fit them (I’ll cover the cost of parts) ∙ The new tap has a slightly narrower base than the old one, so please check it sits firmly over the hole. If needed, a support plate or base plate can be added ∙ There’s some old water damage under the sink near the tap, so please make sure the new tap is properly sealed and test for leaks before leaving ∙ The tap has an antique brass finish, so please handle it carefully to avoid scratches ∙ Please bring your own tools Plumbing experience and reviews preferred. Thanks!