Looking for one registered data cabler to install a wall-mounted network cabinet and run one Cat6 cable at a commercial site in Dandenong South on Friday, 13 November. Estimated on-site time is 1–1.5 hours, depending on access and the final cable route. - Mount a pre-assembled 9RU network cabinet (600 mm wide × 550 mm deep) on the concrete wall at the left end of the office’s rear wall, as marked in the attached diagram. Use suitable concrete fixings. - Run one Cat6 cable along the rear office wall from the cabinet to the marked point at the right end. Drill through the concrete wall there to pass the cable into the adjoining warehouse. - Continue the cable run along the side wall marked in the aerial photo, stopping approximately halfway down the warehouse. Please confirm the mounting point and cable route on site before drilling. Bring suitable concrete drilling tools and confirm your availability, Open cabling registration with structured cabling competency, and which materials and access equipment your offer includes.